I'm about to do just that, providing it's not some sort of limit switch, b/c, the window (dr. side) has a lot more play in it, pivots 2" to 3". My window will go up 2" and stop, if I wait 10 min. it will go up another 2"-3"etc.. So it may be overheating b/c of whatever. But regardless I'll let everyone know what and how I did.
In 94 you had the LT1 350 V8.
factory recommendation is to cut a hole in the inner fender well to access/replace it.
replace the power window motor inside the door. You will have to drill out the rivets and replace with nuts and bolts
Remove the window regulator and motor from the door as an assembly. Drill out rivets that hold motor to regulator and replace motor. Regulator needs to be riveted back into door for reassembly
Try this link, http://www.a1electric.com/grandam.htm. It shows how to replace the entire window regulator assembly (which includes the motor). Probably the cleanest description I have found.
video on how to replace window lift motor on j30
transam
How to remove the window motor from the regulator
The window motor is attached to the window regulator by screws. After removing the door trim you must detach the regulator from the door by drilling-out four rivits. Then remove the screws from the old motor and install the new motor. Re-attach the regulator with bolts and put the trim back on the door.
replace a window lift motor for a 2002 gmc sierra?
replace 1987 dodge pickup/power window motor
Yes