Very carefully! Most need to be bench bled when u first get the new one just press the cylinder Down (open) pour fluid in and release cylinder slowly may have to do this 2 or 3 times. Undo the two bolts mounted to the side of the transmission undo the hydronic line on the old cylinder and put it on the new one. Thenount the new one in place bolt it down and bleed the system
You will have to remove the transmission and then look inside of the bellhousing and you will see the slave cylinder bolted in with 2 10mm bolts. remove the 2 bolts and slide the slave cylinder off the jack shaft.
Master cylinder or drum brake (hydraulic slave) wheel cylinder or disc brake caliper cylinder? drum brake shoes rear
Probably remove the transmissionm if its a internal slave, if external then its mounted on the outside of the tranny. The master clutch cylinder is located on the firewall. Bleed the system and pump the hell out of the clutch after installing the new slave. : On a 99 GST it is an external cylinder (2) 10mm bolts remove the line replace cylinder bleed system.
to replace the clutch slave cylinder... 1. remove the two bolts that hold the slave cylinder to the bellhousing. 2. hang it from a piece of wire..NOT by the braided hose. 3. remove the little pin that holds the cylinder to the hose. ***fluid will leak out of the braided hose... 4. When the fluid has stopped, install in the reverse order...
I would love to help you but i have a 2000 sephia, also check our website www.streetkiaz.com, I am sure we can help you there. :)
how to remove fuel pump on 1996 kia sephia
oil leaks
how difficult is it to replace the MS on a 1996 Honda accord
The slave cylinder is located on the driver side of your bell housing going to your motor. Its a cylinder about the size of a roll of quarters.. maybe a little bigger.
What type of freon does a 1996 Kia sephia has. What type of freon does a 1996 Kia sephia has.
Yes you do. It is inside of the bell housing.
Inside the manual transmission bellhousing