There is no need to remove the door panel. The entire process took less than 10 minutes! Remove the one screw in the center of the handle housing. Slide the old housing toward the front of the car (if replacing the drivers side) and pull toward you. Hold the metal D shaped rod (at the inside rear) with needle nose plyers and remove the plastic clip (the clip swivels to make removal easier). Slide handle housing down from plastic hole. Slide new handle onto metal downrod and slide up. Connect plastic swivel clip to metal D shaped rod. Slide handle housing into opening and lock in place by sliding toward the back of the car. Insert screw and you are done. I bought my handle online for $23 including shipping. The local dealer wanted $36 for the handle after giving me a "ballpark" estimate for them replacing it of $150 to $200! I'm a 56 year old woman so I really think it's criminal that they would charge that kind of money for what took me 10 minutes!
Should have access after removing inner door panel
these are popular to break...drivers side as that is the one that is used more.......the handle does not come alone...you have to replace the entire assembly...around 75.00 bucks...and it is done by removing the interior door panel youll see the screws.....the rest is easy B.C.
To replace interior Ford fusion door handle you must remove the door panel, take off the old handle and replace with the new one, and then replace the panel back on the door frame.
You have to remove the door panel to access handle screws. After that you have to disconnect pulling rods and replace the handle with another one.
Should have access after removing door panels
Should be able to access after removing interior door panel
check Mazda forum. Answer is within
You should be able to access after removing door panels
Remove screw slide handle forward and pull out from panel. Remove from door operner rod.
In the opening where the handle goes through the door panel you should be able to feel a small bolt. Removing this bolt will allow the old handle to come off for replacement.
To replace the window crank handle on the 1993 Geo Prism, first remove the interior door panel. Then, access the screw that holds the window crank in place and remove it. You can then remove the handle itself.
The interior door handle on a Hyundai latches onto the locking mechanism of the door. First remove the old handle by unscrewing it from the door panel. Pull the handle out and remove the locking wire. Install the new unit with the locking mechanism in place. Tighten the mounting screw.