0
How do you replace camshaft position sensor in a Isuzu Rodeo 2.2l?
Wiki User
∙ 10y agoWant this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is a camshaft position sensor on a 2001 Isuzu rodeo?
It is located between the camshafts right behind the camshaft pulley's.
How long does it take to replace the camshaft position sensor in a Isuzu Rodeo?
Not long at all should take no longer then 5 mins
Where is a camshaft position sensor on a 2002 Isuzu rodeo 3.2L?
it does not have one, after 2000 modes the camshaft position sensor is eliminated the these vehicles use the use the VRS system to determine where the No. 1 piston is. therefore they only required a Crankshaft sensor not a Camshaft sensor.
What does code PO341 mean on a Isuzu Rodeo?
PO341 Camshaft Position Sensor Circuit Range Problem
P0342 camshaft position sensor circuit low input how can you fix on 1998 Isuzu amigo 4 cylinder and where is lacated?
How fixed camshaft sensor circuit low input
Where is the camshaft position sensor on 1998 Isuzu rodeo?
On the drivers side head..rear of the head directly behind the intake manifold
How do you repair camshaft sensor on Isuzu Rodeo?
please help
Where is the camshaft position sensor located on a Isuzu trooper?
the camshaft sensor is at the front of the engine next to the radiator, it is held on with one 10mm bolt and is in the middle of the plastic cambelt cover (this does not need to be removed). unclip wire remove bolt and pull.
What is the tps sensor on a 95 Isuzu Rodeo?
It is a Throttle Position Sensor
How do you replace coolant temp sensor on a Isuzu Rodeo?
how do you replace coolant temp sensor on a rodeo
Where is the camshaft position sensor on 1996 Isuzu rodeo?
On 97 & earlier it's located on the front left upper corner of the timing belt cover (3.2L). 2.2L it's on top of the front part of the cylinder head between the camshaft sprockets.
Where is the camshaft position sensor on a 2003 Isuzu rodeo 3.2?
If this is a 6VD1 engine, the camshaft position sensor will be located on the very back of the left bank head (on the inside, under the intake manifold). The easiest way to have it replaced or removed is to take off the intake manifold. The sensor is only secured with one 10mm bolt but it is a frustrating thing to put it back on with the intake installed, unless you have very slim hands.
