Yo go to advanced auto parts and buy a Haynes manual. Ask the what it is if you dont know. There are 2 bolts involved. Its easy.
You should replace the water pump, tensioner, seals, and drive belts with the timing belt. It should be no more than 450 dollars.
Its under the timing cover. Do it each time you replace the timing belt between 60,000 or every 5 years if you don't drive so much. Do the tensioner as well as preventive maintenance.
put it in neutral and shift it to two wheel drive
You have to replace the whole drive shaft.
Begin by loosening the tensioner pulley. Take the old air conditioning drive belt on. Put the new air conditioning drive belt on and tighten the tensioner pulley.
i am trying to replace the belt tensioner on my 1997 ls400 , i got everything loose but there is a plastic seal right in front of it , it is holding the tensioner and there is where i got stuck , can someone tell me how to get the tensioner out without removing the plastic seal . thanks
how do i take a belt tensioner arm off a el falcon
drive universal jount
If the tensioner isn't tight enough it's probably the spring. You can purchase a serpentine belt tensioner to replace the one that has become weak.
fans are driven electronically no belt. The serpentine belt is taken off by taking the tension off at the tensioner and replacing by following the pattern on your strut tower.
Remove the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the accessory drive belt. Remove the accessory drive belt from the pulleys and tensioner. Slowly release tension on the drive belt tensioner. Remove the breaker bar and socket from the drive belt tensioner bolt. Clean and inspect the drive belt surfaces of all the pulleys. Route the accessory drive belt around all the pulleys except the water pump pulley and tensioner. Install a breaker bar with hex-head socket to the drive belt tensioner bolt. Rotate the drive belt tensioner clockwise in order to relieve tension on the drive belt tensioner. Install the accessory drive belt under the water pump pulley. Install the accessory drive belt onto the drive belt tensioner. Slowly release the tension. Remove the breaker bar and socket from the drive belt tensioner bolt. Install the air intake duct, if necessary. Refer to Air Cleaner Assembly Replacement in Engine Controls - 5.7 L. Inspect the accessory drive belt for correct alignment.
no its completely different than 2 wheel drive