Want this question answered?
You need to get the rotor off to replace studs with new ones.
You have to remove the caliper and then the rotor and tap on the front of the stud with a hammer so that it slides out from the back.
Jack the car up and remove the front wheel. Use a jack stand for safety. Rotate the axle until the stud is over the hole in the backer plate. Hit the stud with a hammer, this will take many blows. The stud will pop out. Slide the new stud in, then stack several washers on the shaft and put a lug nut on. Tighten the nut to pull the stud up tight into place. Reinstall the wheel, and over the next few days, keep checking the tightness of the stud to keep it snugged up.
Remove wheel, brake caliper, brake disc, parking brake shoes etc. Drive out broken stud, replace with new stud. Replace above in reverse order.
The front wheel stud on a 1992 Chevy Blazer S10 can be changed by jacking the vehicle up, removing the wheel, and unbolting the caliper. The rotor assembly can then be removed, and the wheel stud pressed or hammered out of its seat.
Are you asking about a wheel stud or exhaust stud, please clarify
Jack up the vehicle and put a safety stand under it. Take the wheel off. With a hammer hit the stud on the tip, several blows should knock it loose. The stud can be pulled out from the rear. Slide a new stud into place, and put to two or three washers on it. thread the nut on, then tighten it. The nut will pull the stud in tight. Remove the nut and washers, then remount the wheel.
Drive the old broken wheel stud out, and drive a new one in. Purchase the new stud at any auto parts store.
Does anyone know if there is a cut out to allow removal and installation of new wheel stud on a 2005 nissan altima? thanks Robert
The hub will need to be removed and the stud pressed or drilled out to be replaced.
First off, it has to be pressed on with a 1 to 5 ton press. So for a DIY person it doesnt make much sence going through the whole procedure. Sorry. But if your hell bent on doing it, message me. A wheel lug stud broke off do you have to replace the hub or does the stud drive out?
HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?