How to change the Instrument Panel (Dash) lights in a 2001 Toyota Sienna. Note! You should disconnect the Negative battery terminal before you start. If you do it will be a few trips before the engine runs and shifts normally. All electrical plugs have a catch. You have to find the correct place to push in, before they will come apart. All of the screws are #2 Phillips. # Remove the two vertical screws in the trim panel above the cluster. # Grab the bottom of the trim and pull strait back. Note, the center AC vent comes with it. # Un-plug the wires and set it aside. # Use a thin plastic putty knife to get under the left and right edges of the square Radio trim. Pry it strait out and let it hang from the wires. # Above the radio face there are two screws that go strait up into the big piece of trim around the cluster. Take them out. # There is another vertical screw on the left side below the dimmer. Remove it too. # Look strait at the dash for the heads of two obvious Phillips head screws. Remove them. # Pull the top of the big tunnel towards you. If you got all of the screws it should roll towards you until it is stopped by the wiring. # Unplug everything. If you have an alarm the plugs may be in a ball of foam tape and cause you fits. Scrape off the tape. You may have to lower the knee bolster, under the dash, to get to the plugs There are little catches to find and push. # You now have easy access to the cluster. Take out the 4 screws and roll it towards you. # The panel lights are the 4 biggest sockets. The bulbs are 194s. # Plug the dimmer back in, hook up the battery, turn on the lights and check the bulbs. Mine all worked after I fiddled with them. I replaced all four anyway. # Remove the green covers carefully. The auto parts store won't have them. # When you put it back together don't forget the light for the ignition switch. You may not have noticed it unplug when you took the big piece off. Good Luck Al
Remove the instrument panel cover retaining screws. There are four screws that need to be removed. The instrument panel light bulb's will be visible. Push the light bulb in and turn at the same time to remove the light bulb.
Do you still need an answer? yes
Follow the instructions on Youtube.
you take apart the dash and get to the instrument panel. then you take the instrument panel out and on the back of the panel you'll will see the lights
How to replace intrument panel lights on 2002 cadillac escalade
It could be not a bell, but seat belt reminder light. See "Indicator symbols on the instrument panel" in the Owners manual.
To change the dash light bulbs you must remove the instrument panel.
The odometer light fuse also controls other lights on your instrument panel. The odometer light can be removed by removing the instrument panel cover. Push the light bulb in and turn at the same time. The light bulb will come out. Replace it with a new light bulb.
light in instrument panel go dim can i ajust it
take out the instrument panel and it is on the top left side small bulb. but if you have more then one burnt out replace them then
How do you change the light bulbs in the instrument panel in 1998 Toyota corolla
I doubt that all the lights went out at once so lets start with the light switch. Either the switch or something on the light switch panel turns or slides to control the brightness of you instrument lights. It can also shut them completely off. So try that first. Next xheck the fuse panel for the fuse marked inst panel. It is most certainly one of those two things. If not you can always have the light switch or the instrument panel tested. Good luck.