0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
How do you replace 2001 Chevy silverado rear main seal?
How do you change a rear main seal on a 2001 Chevy 2500 HD long bed
Differential oil leak on 2001 ford escape how do i fix iT?
A 2001 Ford escape differential leak is usually caused by a bad seal. Replace the differential seal. The new seal should stop the oil leak.
The dust boot seal on the rear caliper is broken on my 2001 Passat. What can happen if I don't replace it Can it be replaced How difficult it is?
The brake caliper boot seal keeps out dust and dirt. If not replaced it can cause the caliper seal to leak and the brakes to possibly fail. It is simple to replace.
What is the cost to repair a rear main seal on a 2001 ford ranger pickup?
I just gotten a quote for a 2001 ranger 2wd 3.0 automatic. The quote was $550 to replace the rear main seal. This is from a privately owned repair shop.
Where is the rear oil seal located on a 94 Chevy Lumina 3.1 engine?
The rear oil seal on any automotive engine is located at the rear of the crankshaft, which is usually only accessible once the oilpan is removed. The exceptions to this rule concerning the oilpan still involve removal of the flywheel or flex-plate to gain access, as these seals are installed from the exterior of the crankcase onto the crankshaft.
Leaking Volvo 780 sunroof?
Try seaking seal
How do you replace the seal on a water pump from 2002 Chevy Avalanche?
YOU DON'T!!! I have a 2003 avalanche and I had to replace the water pump you can't replace the seals!!! It's a defect in the 2001 to 2003 avalanche the seals fail.
How much does it cost to replace the rear transmission seal on a 2001 ford expedition?
The seal should run about 10 dollars or less. The mechanic shouldn't charge more than 40 dollars or so. It is a pretty easy job. Buy the seal, remove the driveshaft, knock the seal out, replace it with the new one and reinstall the driveshaft. Piece of cake. good luck.
What is the best way to replace the oilpan gasket on a 1984 300ZX?
There is not really any easy to do it. You just have to sit the new gasket around the rim of the oilpan and bolt it back on. Just make sure that the gasket is centered or it will not make a good enough seal. However you could use a small amount of sealent glue or something simalar and stick the gasket into place before putting the pan back on, but only a very small amount or you will create a gap.
How replaced transmission seal my Tahoe?
Front seal: remove engine or transmission and replace the seal. Rear seal, remove the drive shaft to replace the seal. Unfortunately, you typically only have problems with the front seal.
How do you replace a rear wheel bearing and seal on a 98 Toyota Tercel?
how do i replace a wheel seal
How do you replace a leaking rear axle seal on a 2001 F250 7.3 Diesel 2wd?
You will have to first find out if there is a hole in the part. If there is, then you need to get it replaced.
