start by removing one wire at a time. Replace it with the closest length matching wire. Do this one wire at a time. What ever you do, don't pull all the spark plug wires at once. You might not install the wires in the correct order. good luck.
Check firing order
Replace your spark plugs, wires, cap and rotor. Change oil and filter. Change air filter, pcv valve.02 sensor.
I need to know also. I can't get the spark plug wires off!
POSSIBLY UNDER THE DISTRIBUTER THERES ALOT OF WIRES GOING IN THERE
The spark plug firing order is 1 - 3 - 4 - 2 The distributor rotor turns CLOCKWISE ( for both 2.0 L and 2.3 L - 4 cylinder engines in a 1987 Ford Ranger )
the ignition module is on the distributer(the thing all the spark plugs wires go to)
The coils are held in place with two small screws. Remove the spark plug wires making note of where each wire goes, then remove the screws and pull the coil straight out. To replace the coil line up the connectors and push the coil in place, then put the screws back in and reconnect the spark plug wires.
Use A Ford Ranger Repair Manual (1983-1992) And It Will Tell You What To Do And Give You Specific Pictures.
1,8,4,3,6,5,7,2 1,3,5,7 are on the left bank and 2,4,6,8 are the right bank.
Need to know what year and engine size.
Replacing the flywheel on a 1987 Ford Ranger 4x4 can be pretty complicated. The best best would most likely be to bring the vehicle to an accredited mechanic and enlist the help of a professional.
=No it will not have a spark!==No it will not have a spark!=
Space Ranger - 1987 VG was released on: USA: 1987
No, replace the converter with a new one. Anything else is illegal.
You can find the correct firing order for your 1987 mercury cougar at www.coolcats.com, it is a website dedicated to the cougar and thunderbird.
CHECK FOR BROKEN WIRE OR WIRES ON THE MAIN HARNESS OR SMALLER ONE OFF OF THE MAIN NEAR TO THE BATTERY FUEL AND SPARK WORK TOGETHER , IF YOURE GETTING FUEL AND NO SPARK CHECK THE COIL
that is stamp on the intake right rear. 65;
Airborne Ranger was created in 1987.
Airborne Ranger happened in 1987.
To change the spark plugs in a Chevy Celebrity: 1. Give the spark plug boot a twist to free it up from the spark plug, then pull on the boot to remove the spark plug wire from the spark plug. 2. Use a 5/8" spark plug socket with an extension and ratchet or breaker bar to loosen then remove the spark plug. 3. Set the gap on the new plug to .045" then screw it back into the spark plug hole in the head. Tighten the spark plug and replace the spark plug wire. I change the spark plugs one at a time to keep from getting the spark plug wires on the wrong spark plug.
pull the spark plug wires out from the valve cover and unscrew the four nuts it will come right off.