Want this question answered?
How do you install a rear sway bar on a 2003 f 150 4 wheel drive
Do you mean Stabilizer Bar?
unbolt stabilizer link and replace with new one (be careful, wear proper safety equip. may spring loose, do not lay directly under or over the stabilizer link.
The CV joint in a 2002 Ford Mustang can be replaced by removing the front wheel, and the cotter pin and nuts. Next, the tie-rod end, and the stabilizer bar link, will need to be removed and the CV joint can be removed from the housing when removed from the knuckle.
I believe it is a 15mm nut and bolt. You need to undo both stabilizer links and pull the bolt out of the stabilizer link shaft. Sometimes these parts will rust together or corrode and can be tough to pull apart but they will come apart. Then you just replace the old with the new. total job time for both sides... 20 - 40 mins. hope this helps.
Depending parts you are planning to use. I would expect for the link bar $25-80 plus at least one hour of labor.
Check out the related link for a video on how to replace a crankshaft position on a Ford Focus SE.
Click on the link below Click on Owner Guides The owners manual ( which includes the fuse box diagram ) can be viewed on-line
You did not state the year, but assuming 96 or 97, there is a photograph available at this link: http://autocenter.weber.edu/OBD-CH/documents/newdocuments/ford/aerostar1996.jpg
See link below
link pins. bushings and links Stabilizer link bushings.
See the Related Link for "autozone.com" to the bottom for the answer.