GM and GMC
Ford Explorer
Chevy Tracker
GMC Envoy

How do you replace sway bar links on a 1992 GMC?

717273

Top Answer
User Avatar
Wiki User
2006-07-17 02:34:07
2006-07-17 02:34:07

Most of the time, the old links are corroded together, and it's much easier to use a cutting torch to remove them. Once they are removed, install new links & bushings (bolt, washer, rubber, sway bar, rubber, washer, sleeve, washer, rubber, control arm, rubber, washer, nut)

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

I need to know how to replace a heater core in a 1992 GMC Jimmy?

User Avatar

Where is the AC sensor located on a 1992 GMC pickup

User Avatar

GMC Typhoon was created in 1992.

User Avatar

How to replace o2 pre converter gmc 1500

User Avatar

GMC K3500 didn't have a MAF sensor in 1992.

User Avatar

how to replace wheel bearings on 2004 GMC envoy?

User Avatar

The fusible links on GMC sierra are on the firewall, left side (passenger) of engine compartment.

User Avatar

replace a window lift motor for a 2002 gmc sierra?

User Avatar

Unscrew the trim piece around the headlights, be careful as to not lose this. Pull the light out, unplug, replace. Simple as that

User Avatar

They're sealed. If the shocks are leaking you'll need to replace them. Always replace them in pairs, both sides at the same time.

User Avatar

The starter relay on a 1992 GMC Sierra is in the engine compartment. It is located on the passenger side near the front.

User Avatar

= How do you replace the rear dutch door latch on a 1997 gmc safari?" =

User Avatar

How do you flush the raditor on a 1992 GMC Sonoma Pickup.

User Avatar

gmc 1500 sierra was fuel injected in '92

User Avatar

I have a 1999 gmc 1500 sierra,need to replace door pins and bushings.door sagging.

User Avatar

Sure you could replace it or rebuild it, but you're better off buying a new starter and getting the core fee back ;)

User Avatar

How do you change the abs pump on a 2001 gmc jimmy

User Avatar

How to Replace a Cabin Air Filter on a 2006 GMC

User Avatar

I am not showing a 2010 GMC Envoy...do you mean 2009

User Avatar

OK the heater is not letting the heat into the cab of my truck-I think the switch that controls the deflection doors is broken what is my answer the best thing to do.

User Avatar

You have to have an Allen wrench to hold the ball joint straight while turning the nut with a wrench. Once you get it loose a bit, then you can hold the ball joint still with a set of vise grips and remove the nut the rest of the way. It is good to let it soak with some penetrant oil first. Buy after market style links and they have a place for a wench on the ball joint so it is easier to hold than the stock type. Moog is a good replacement part.

User Avatar

how do I remove door lock 99 gmc savana

User Avatar

You simply unscrew the antenna rod and replace it. Very easy.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.