apply parking brakes jack front end of car up and put on jack stands remove tires remove brakes and rotor remove spindle by taking of twwo bolts and nuts pull spindle forward take off cv bot clamps and cv shaft will slide out
i recommend getting a haynes or chilton repair manual for your car. itll give you step by step instructions and pictures on how to replace your half shaft and a lot more.
No you do not.
How do u replace the front axel on a 1997 nissan altima
I dont believe a 2003 Sentra has a propeller shaft because it is a front wheel drive vehicle. Only rear wheel drive vehicles truly have a propeller or DRIVE shaft. It runs down the center of the vehicle, length ways, connecting the output end of the transmission to the input end of the differential.
the timing marks are the the triangle on the cam shaft and there is a plate in the back of the cam shaft that has a groove at the top of the plate.line bot of them up then your car will be timed.
Depends on what's wrong with it. If it is the base of the arm stripped out where it attaches to the shaft you replace it, or you can take it off and put some JB Weld or epoxy glue on it and bolt the arm back one. This may make it permanent, but it's a cheap fix.
pull the drive shaft the trans cross member the trans and its right there
Take a huge poo on your bonnet that should fix it !!haha
I would say it is the left axel shaft.
You have to replace the whole drive shaft.
i need to replace the flex shaft in my weedeater. how do i do it?
It is in the oil pan. Nissan has had a recall to reprogram the sensor. They may have to replace the sensor for free. It cost about $600 for repair.