answersLogoWhite

0


Best Answer

Not sure on a 2002. But I changed mine on a 2004. More than likely, the same place. The sending unit is in the fuel tank. This is located under the rear seat. Remove the rear seat (pull tab, 1 on each side, lower front). You will see an access panel. Best to do this job when fuel tank is low. Remove the panel. Remove electrical connection, remove hoses, remove bolts. Fuel pump and sending unit all comes out together. Replace sending unit, re-install unit. Found sending unit on-line (don't remember where) 45. - 50.00 bucks) Mitsubishi dealer wanted 400.00 to replace. Good luck

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you replace the Fuel Level Sending Unit on a 2002 Mitsubishi Diamante?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How to replace 2006 Nissan exterra fuel level sensor.?

Refer to repair manual for proper instructions Remove gas tank remove sending unit replace with new sending unit and properly reinstall sending unit and gas tank


Can you replace the power steering fluid pipes on a Mitsubishi space wagon?

Yes but you have to be in level three orbit to do so


How do you replace the Oil Level Sending Unit on a Malibu?

The sensor screws into the side of the oil pan. You will need to drain the oil and then replace the sensor.


Do you drop gas tank to replace 95 crown Vic fuel level sending unit?

yes


How do you replace fuel level sensor on 2001 lesabre?

Replace sending unit which is located inside gas tank (gas tank must be removed from car).


How do you replace fuel level sending unit 1994 Chrysler LHS 3.5?

there is an access plate in the trunk. Remove carpet remove and replace. Beware of gas fumes and spillage.


The oil light in 1988 Mitsubishi mighty max pickup comes on why?

If the oil light comes on but the oil level is ok, the problem may be a faulty sending unit, as it turned out in my case.


How do you replace a fuel level sending unit on a 2000 Pontiac Montana?

you will need to take the fuel tank out because it is inside of the tank.just put a new fuel sending unit in and you should be good to go.


What do you have to remove to replace the sending unit?

There are several sending units, engine temp, oil pressure, fuel level to name a few. We need to know which one and also the year, make and model vehicle.


Location oil level sending unit 6.6 duramax?

location of oil level sending unit 6.6 disel


How do you replace a fuel level sending unit in a 1993 Mercury Capri?

Remove the rear seat...You'll see the sending unit with the connectors(it's a metal plate)...Remove all the screws,unplug the connectors and hoses and the whole sending unit comes out in one piece....It's very easy//


What would cause an oil light on a 2000 grand caravan to stay on?

oil pressure sending unit could need replacing, or you could have low oil level. I recently had to replace my sending unit after putting too much lucas oil stabilizer in.