First, disconnect the battery cables, Second, you have to drain some or all the coolant so you can remove the upper radiator hose, Third, disconnect the alternator cables, Fourth, loosen the bolt attaching the alternator so you can loosen the alternator belt, Finally, remove the bolt and angle the alternator to remove it. You might need to hammer the alternator from underneath, sometimes they are really tight. 'Hope this helps.
BeltsYes, you must remove all of the belts to replace the alternator belt. The compressor belt first, then the power steering belt then the alternator belt.
Were is the timing mark an a 1994 Nissan sentra 1.6l?
To replace the headlight bulb in a 1994 Nissan Sentra first prop the hood of the car. Locate the headlights and remove the bulbs from the housing. Install the new bulbs.
How do yu adjust idle in a nissan sentra
1994 Nissan santra firing order
how do you remove a distributor rotor on a 92 Nissan sentra
on yours, you will have to remove the bottom shield and work from the bottom of truck.Remove wires from alternator,remove pivotalbolts and remove alternator and replace and tighten belt back.
how do you change the ignition key switch on a 1994 nissian sentra se
what year maxima? 1989-1994 on the bottom.. 1995-2000 in the middle..
It is not equipped with one.
yes the trans is the same in all 91-94 for the 1.6L motor
4 bolts at the filler and the other you have to put your head under the car and look
I had the same problem and then my alternator went out. Replaced alternator and haven't had the problem since. Check your belts.
Yes, but with improvements along the way. Better camshafts etc...
on the side of the engine
To find the ignition key code for a 1994 Nissan Sentra SE, check the owner's manual. You can also contact the manufacturer to obtain the code.
REPLACE THE PASS SIDE HEADLIGHT
no because the maxima is a 5 lug and the sentra is 4 lug
replace your pressure plate (diaphragm type), and the clutch. replace your pressure plate (diaphragm type), and the clutch.
do a coolant pressure test.
It's by the flywheel housing.