How do you replace the blower motor in a 2004 Chrysler Pacifica?

Answer 1

ALWAYS DISCONNECT THE GROUND BATTERY CABLE TO AVOID INJURY BY THE AIRBAG DEPLOYING!!

The blower motor is located above the front passenger's feet.

You can lower the glove box by opening it and pressing the sides together to allow the box to hinge down. There you will see the 2 connections to the blower motor resistor.

Disconnect the green/black wire connector. This goes to the blower motor.

Now, you must get on your back on the passengers floor board to see the blower motor.

You will notice 8mm hex head screws that hold the lower cover onto the blower motor assembly. Also, there are screws that connect a small gear assembly that controls a baffle inside the assembly. Use a small ratchet and socket assembly to remove this first. You can leave it connected.

Now, there are 4 easily accessible screws that you need to remove. The last is near the firewall, and it is a bear to remove. I used a cordless drill with a socket extension and felt with my fingers where the screw was located and removed it.

There is a rubber gromet that goes thru the lower cover that the cables go thru. Push the gromet and cables thru the cover to remove it.

Now, there are 3 screws that hold the blower motor assembly.

Remove the 3 screws and remove the blower motor.

Installation is in reverse order.

Good luck, and I'll be praying for you!