The bulbs used in this car are dual filament and one filament is broken. The filament that makes the brake light come on is the same one that is used for the turn signal. Simple solution - replace the bulb. The owners manual for the car should have instructions on how to do this as it is usually considered a repair that can be performed by the owner. If you don't have the manual I would suggest checking the internet for instructions or taking a look inside the trunk to see if you can figure out how to access the bulbs. Any auto parts supply will stock the bulb since it is a common problem.
Most common cause of the turn signals not flashing is a defective flasher relay. Replace it.
it doesnt it doesnt
No the brain doesnt
so your car doesnt roll down the hill
if the boy talks to u or loks at you then he likes you but if he doesnt then he doesnt like you but if he is giving u mixed signals then he loves u
Possible malfunction with the alarm. Thats if the car has an alarm (mine doesnt) Could be a possible defect with the light switch itself which also opperates the parking lights.
Check the fuse for parking/tailights (dash lights also on this circuit)
Replace the thermostat.
The most likely culprit for a do-nothing parking brake is a misadjusted cable. Generally there is an nut that can be used for adjustment at the rear of the vehicle that will allow you to tighten or loosen the parking brake cable.
Probably the Electronic Flasher. These ,when the fail,will allow the Signals and/or hazard lights to work intermittently. The flasher is the same for both the signals and hazards.
Either your turn signal bulbs are out or the wiring leading to your turn signals is not properly connected. Most likely your bulbs are out which will only cost a few bucks.
Try Windex & a soft cloth if that doesnt do it Try Pam cooking spray, soft cloth of that doesnt work Try WD40 & soft cloth if that doesnt work, replace the board.