Frist take the caliber off there should be two caliber bolts holding it to the bracket.After removing the caliper you can remove the brake pads.I keep the one pad to the inside of the caliper in till I push back the piston with a large c clamp or a big pair of plyers.But make sure to open the brake bleeder to let out the fluid not to brake the anti lock system.Then close the bleeder and put the new pads in and reverse the way you took it off.Make sure to not over titen the bolts. take the cover off the master cyclender and then open the bleeder screw till some of the fluid comes out then tighten and replace the top back on the master cyclender,and go to the other side and the same aplies to that side.But after you are done make sure to pump the pedal a few time till it gets hard then check the fluid level.
If you are wondering whether it is possible to replace one's own brake rotors or not because you drive an older vehicle that need brake rotors replaced, then the answer is no.
no but it is recomended.
type brake fluid for car?
It's less than 2 hours work - depends on local labour cost.
The 1995 Oldsmobile Cutlass brake rotors will cost approximately $40 per wheel. The rotors can be as cheap as $25 at some discount auto-parts stores.
when needing brakes do you have to replace the rotors to on a s60r
Check, or even better replace, the wires.
depends on the condition od the pads. If worn or have groves etc from the rotors then replace.
how much does it cost to replace brakes rotors on honda crv
take it to a shop
Pull the tires off and take the brake calipers off and the rotors will pull off.
1500 or 2500???