0
It would be to your advantage to purchase a Haynes Manual specific to your car. They can be purchased at most parts stores.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
What is the CV joint nut size on a 1993 Geo prism?
For my 94 Geo Prizm it's a 30mm.
How much should it cost to replace cv joint in geo prism?
Parts will cost about $100-$150 US and labor will be another 100-150 US.
What is the clicking and scraping noise you hear when you make hard right or left turns in a geo prism?
I would suggest have it checked with a "trusted mechanic".,but I would wildly guess it could be your CV-Boots worn out-or just need to replace the driving axle- which the noise coming from...hope this help!!
Time involved cv axle on a 95 geo prism?
I just had the shop do the work. It was about 200 dollars for the parts and labor, and it only took like 45 minutes. Just save yourself the frustration and have a shop do it.
Replace cv joint on Lincoln LS?
don't replace the joint. replace the axle
CV boot Ford Ranger how to replace?
A CV boot is found on the axle of a vehicle. To replace the outer boot remove the axle bolt and pull the boot off. The inner boot requires removal of the whole axle.
How do you replace right cv axle 2002 ford escape?
how to remove, or replace front right axle escape 2004
How do you replace a cv joint in a Honda Odyssey?
Much better to replace the whole axle, look at www.happywrenching.com for a guide on how to replace an axle in a Honda Odyssey
How do you replace 2000 dodge ram 1500 front axle cv joint and boots?
The 2000 Ram had u joints, not cv joints at the front axle.
Does a 1991 toyota corolla have cv joints or do you have to change the whole axle?
It does have CV joints but, it is best to just swap out the complete axle assembly than to replace only the CV joint. You will spend much time and almost as much money trying to replace the CV joint than to just purchase a reconditioned axle assembly and swap it.
Can you replace a CV joint on a 92 prism with parts from a 91 prism?
Yes the CV axel will fit from 89- 92 also from 98-92 Toyota Crolla
You are ready to replace an axle in your 1993 Nissan Sentra and the axle is stuck in there It will not come out What can you do to get the axle out?
they make a fork to put in between the transmission and the cv axle that attaches to a slide hammer, supporting the cv axle and using the slide hammer the axle should pop out (note I have seen the fork damage the housing of the cv axle if it is a very stumbern fit).
