Nissan Xterra
VW New Beetle
VW Passat
Late Model 1979-New Ford Mustangs

How do you replace the front and rear side marker light bulbs on a 2002 Beetle Turbo S?

242526

Top Answer
User Avatar
Wiki User
2007-12-26 02:15:44
2007-12-26 02:15:44

It may be spring loaded and the whole unit can be pryed out while being careful not to scatch the paint. I'll let you know if it works after I try it next week.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

my front headlights dont come on all the just one if i slam the trunk will come on what do i do

User Avatar

Replace the indicators and if that doesnt work replace the bulbs because that means either one or the other is going bad.

User Avatar

go in your trunk and there are covers where the brake lights are...remove covers, unscrew plastic nut, and remove light...

User Avatar

You have to take off the plastic shrouds in the inside of the wheel wells. There are about 4-5 plastic "push-in" screws (or snaps) that you have to pop out, then remove the shroud, and when you look into the wheel well you will be able to see the marker lights. Pop out the bulbs and replace but be careful because often times the bulbs have shattered and you'll cut yourself. Good luck.

User Avatar

The side marker bulbs on a 2002 Buick LeSabre are replaced by removing the retaining screws and disconnecting the wiring harness. The old bulb can then be removed and a new bulb put in its place.

User Avatar

It should be the same type of bulbs that are in the side marker lights. They should be #194 bulbs if memory serves.

User Avatar

If you're referring to the tail lights, remove the 3 screws to remove the lens. Change bulbs, reinstall lense.

User Avatar

Daytime Running lamps are replaced following the same directions as replacing regular headlamps. First lift the prop the hood open on a 2007 VW Beetle and locate the headlights. Find the light bulbs and remove them from the housing. Replace the lamps.

User Avatar

-- Without changing the bulbs, increase the voltage of the battery or power supply. -- If the bulbs are in series, take one out of the circuit, and replace it with a piece of wire. -- Replace incandescent bulbs with others whose filaments have lower resistance. -- Replace incandescent bulbs with fluorescent tubes. -- Replace incandescent bulbs with LEDs.

User Avatar

To replace the bulbs in a 1997 Acura safely prop the hood open. Locate the front headlights and remove the old lights. Replace the bulbs.

User Avatar

I've replaced the front marker bulbs. Take a flat smallish screw driver, and insert it behind the yellow lens. Carefully pop it out. Move the lens towards the rear, to unhook the 2 plastic tabs. (don't force it or you'll break them off!!) The bulb is now exposed. Pull it straight out, and replace it. You might try wiggling it abit first. It might just be a poor, corroded contact.

User Avatar

The 2002 Chevy Avalanche does not have user replaceable radio bulbs. The radio needs to be dismantled by a qualified technician to replace the bulbs.

User Avatar

To replace the brake light bulbs on a VW Polo, pull away the carpeting in the trunk, unscrew the bolt holding the lights on, and disconnect the wiring. Replace the bulbs, put the wiring and bolts back, then replace the carpeting.

User Avatar

If the left or right bulbs light up but don't blink, replace the flasher. If none of the bulbs light up, check the fuse. If one or more bulbs are not lighting up, replace the bulbs.

User Avatar

Are you talking about the side marker bulbs on the front bumper? These bulbs should have a access panel from behind them. Look in front of the tire, on the front part of the platic wheel well liner. Should be a small hole that has a release tab, press that tab to release the side marker lens. Then you can just pull the old bulb out, and re-install.

User Avatar

The bulbs are located for the headlights under the hood of the car.

User Avatar

It is true to say that Halo headlights bulbs can be replaced.

User Avatar

Changing out side marker bulbs are easy. All you have to do is unscrew the old one and screw in the new one.

User Avatar

There are no individual bulbs, just LED's in the dials, and you will have to replace the entire instrument cluster.

User Avatar

It is completely up to you. If you do update your bulbs you will probably save money in the long run. You don't have to replace all your bulbs at once replace one or two at a time that way you aren't spending too much at one time for new bulbs.

User Avatar

Bulbs gone There are 8 in the unit. Replace with ebay bulbs 1.2w or 2.2w Replace ALL

User Avatar

the whole light or just he bulbs?? just the bulbs

User Avatar

you need to remove the tail light lens. There is a large round plastic cap located behind the lens in the truck .Remove the cap and there is a black plastic nut that you can remove by hand, that will release the lens and you will be able to replace the bulbs.

User Avatar

Unscerw the dash board, replace burnt bulbs, screww back dash board

User Avatar

How to replace passenger side head light bulbs in a 2000 Honda Accord?


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.