Without model of 1999 Mazda, its impossible to give detailed instructions. In general however, most owner's manuals will have instructions and illustrations for turn signal bulb replacement. Also, see sources and related links below for more information on the correct light bulbs.
trouble putting right front signal bulb in.
on what car
Check the fuse for the wipers and replace the turn signal bulb.
remove passenger side signal front light first then passenger headlight and horn should be right behind below the side passenger signal light!
Get a creeper and go at it from the bottom, all of what you need is right there.
The right side will have a burnt out/ missing light bulb.
i need to replace a throttle sensor and put a throttle body rebuild kit in
The horn for the 1990 Mazda Protege is located near the right turn signal at the front of the car. To the left of the radiator when your looking at the engine with the hood up.
One of the front blinker bulbs is burnt out. Replace the bad bulb and the blink should function normaly. you have a front right turn signal bulb that is burned out. the resone it blinks fast is there is less load on the flasher .
For the front there is a tiny bolt above and to the outside of the headlight assembly that screws thru the fender into the turn siignal assembly. For the back the assembly is screwed in by 2 screws on the tailgate side and 2 screws on the outside.
First pop your hood. After you raise the hood, and your looking at the front headlights. Directly above the headlights. In each corner of the headlight is a screw. remove that screw and pull the signal light right out. turn it over to replace old bulb. Once your done reinstall turn signal. Then tighten screw back!
Reach behind the bumper of the 99 Cavalier. There are two nuts that hold the turn signal assembly in. Remove the nuts to take the assembly off and replace it.