answersLogoWhite
Shocks and Struts
Chevy Astro
Toyota 4Runner

How do you replace the front shocks on a 1996 Chevy Astro?

111213

Top Answer
User Avatar
Wiki User
Answered 2007-02-16 15:24:39

The shocks are very easy to replace. You have 2 bolts holding the bottem on and 1 on the top. Remove the from wheels. You can use common ratchet set. Don't take to shop. Replace them yourself. Will take no more than an hour with an unexperienced mechanic.. The rear are the same, except do not remove the wheel. Easy stuff.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


Does Chevy cavalier have front shocks


how to change front shocks in 01 Chevy s10


There are no front shocks on any Beretta. Shocks are in the rear. Struts are in the front.


The 2000 Chevy Silverado 4x4 has shocks in the front.



Struts on the front, shocks on the rear.


2005 Chevy Malibu, shocks in rear, Struts in front.


you can get to some from the front and the ones in the back you can get to through the wheel wells


Remove the positive cable from your 1988 Chevy Astro battery. Remove the cables from the front of your starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


Remove the positive battery cable from your 1999 Chevy Astro battery. Disconnect the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install the new starter.


Rear shocks are easy however the front shocks require spring compression devices that must be used properly or you could get seriously injured or killed. The Heavy duty Bilstein shocks are very popular with the people at our enthusiasts forum. www.trailvoy.com


It will be easier if you pull off the front tires then you have the shock bolts at your reach. It took me 30 min for both front shocks.


A 2006 trailblazer has 2 struts in the front and 2 shocks in the rear


1997 s-10 blazer has shocks,on both front and rear.


Remove the tire and wheel from your 1997 Chevy Astro. Remove the axle end. Remove the wheel bearing nut. Remove the wheel bearing and the wheel seal. Reverse the process to install the new front wheel bearing.


It does not have shocks on the front it has struts which should only be replace by a professional. The rear shocks are easily replaced. Just unbolt them and install the new ones.



When you find it faulty and need to be replaced


a 4 door 97 blazer front how do i do it



Jack car up and remove tires for easy access, then simply unbolt front shocks and replace with new shocks. On the rear some models come with a type of ride leveling shock that will be noticeably fatter than a normal shock, this type of shock called Nivomat MUST be replaced with a comparable expensive Nivomat shock or you need to buy a replacement kit that includes new springs and regular shocks, this kit uses different springs to compensate for the non Nivomat shocks. To replace rear shocks you would follow similar steps to the front, jack up car, remove tires and simply unbolt the shocks and re-install the new shocks in the same order.


Lift the front of the vehicle up and support it with jack stands under the lower a-frames. Remove front wheels. Unbolt front shocks and remove them. Reverse order to install.


On a 2004 Chevy Astro, the camshaft sensor is located in the front of the engine. It is on the left side of the timing cover behind the camshaft sensor.


165432 #1 cylinder is left front


Chevy astro van? on the front ballencer



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.