There is a hole on the edge of your hood that is directly behind the turn signal lamp. When you look directly inside, you'll see a piece of plastic. That's not where you need to go. Instead, go about 1 inch behind that and about 1 to 2 inches deeper. That's what you need to push down with a flathead screwdriver. Push down and forward to nudge the lamp out of its socket.
Hope this helps someone. It took me a LONG time to finally get mine out. I wasn't ready to pay another arm and leg to change something that was supposed to be simple. :) Good luck.
http://m3.madrussian.net/diy_front_turnsignal.shtml
AnswerExcellent help provided here - The only thing I would add is that you may want to use an extra long flathead screwdriver. The plastic tab that you need to press down on is pretty deep inside the hole.Answer
I agree this is excellent help. I just wanted to add that this also works for a 1999 BMW 323.
ANSWER
So easy!! Look in the little hole, the second in from the front. You'll see a little silver tab. It's plastic, don't break it. The tab you need is about 1.5 inches below. Poke around. It will just pop out, THAT EASY!! Don't remove any thing from the headlight assembly.
HOW DO YOU GET THE LEFT TURN SIGNAL BULB OUT ON A 2000 PONTAIC FIREBIRD
How do you replace a front turn signal bulb for a 2000 sts cadillac?"
This is the turn signal bulb in the front bumper - passenger's side.
Go to this link, http://www.e46fanatics.com/howto/howtodetail.php?howto_id=43
a Phillips head screw driver
I just changed a turn signal bulb in my 2001 330xi. I found the answer on Wiki. Look for the question "How do you replace the front turn signal bulb located on a 2000 BMW 323?" Same design. And, surprisingly, very easy to change. Should be similar to this: http://m3.madrussian.net/diy_front_turnsignal.shtml
Replacing a front signal turn bulb on a 2000 Chevy cavalier takes all abut a few minutes to complete. First find the housing for the turn signal which is located in the engine compartment. Pull back the bulb from the light housing and remove it from the clip. Lastly install the new light.
Check the fuse for the wipers and replace the turn signal bulb.
How do I install a turn signal switch for a Chevy 2000 Impala? WHere is the old part that I need to replace?
were is the turn signal located in a 2000 ford escort zx2
How do you change front signal bulb on 2000 acura RL
how do i replace front wheel bearinbs on 2000 ford ranger 4wd