1. Open hood and locate the light assembly (left or right). On bothsides of the assembly you have a white piece of plastic that slides up and the whole unit comes loose. Make note where the light assembly connects to the car before removing the assembly. 2. Unplug the wire harness so the entire unit can be removed. 3. On the back of the light assembly, remove the round rubber piece for the bulb you want to replace to expose the light socket. 4. Turn the socket counterclockwise (about 90 degrees turn) and pull the entire bulb socket out. 5. Remove the old bulb from the socket by grasping near the base and pulling. 6. Insert the new bulb (in the same direction as the old one). 7. Reinsert the socket into the assembly by aligning the tabs on the socket with the holes in assembly and turn clockwise (about 90 degrees) to relock the socket in place. Then replace the round rubber piece. 8. Reconnect the wire harness and reinstall the white pieces of plastic to hold the assembly in place. Good luck. Should take about 5 minutes to do this.
How do you replace the front turn signal bulb located on a 2001 Buick Century?"
Need more information, is it a front or rear, side marker even?
1999 Buick Century Turn Signal Bulb Numbers can be looked up with the link below in Sources and Related Links.
safe lite repair safe lite replace
Go to the person you got it from and ask them
The turn signal Flasher Relay is located… Front seating area, center, under dash, mounted in front driver side of console.
Remove headlight assembly to access bulb/socket.
Replace axle on 2001 buick Lesabre
Im not sure if its the same as a 1990 Buick century you have to pry up the speaker/defroster cover using a screwdriver. The speaker than has two screws securing it to the dashboard.
What are the brake rotors minimum thickness on a 1997 Buick Century? Thanking you in advance.
The front door speakers in a 2003 buick century are 5 1/4 inches.
I just replaced the front signal light in a 2002 Century, it's probably the same or similar. Pull up on the two white plastic clips on both side at the rear of the light assembly. Pull the light assembly forward amd remove the black rubber circle behind the bulb. Remove the bulb assembly by turning counter clockwise. Pull out bulb. replace bulb and repeat steps in reverse order.