Dodge Ram

How do you replace the front wheel bearing on the driver side of a 2001 Dodge Ram 1500?

363738

Top Answer
User Avatar
Wiki User
2015-07-15 21:09:44
2015-07-15 21:09:44

If you have 4wd the bearing is pressed onto to hub and can't be change. The unit is sold as a whole as a bearing hub. The cheapest I have found it was $171 at autozone.

same is true for the 1500 2wd, only AutoZone doesn't have it listed! I had to get mine from the dealer. However, the dealer gave me a 8-lug hub instead of a 5-lug, but it had the same bearing.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.

User Avatar

how do i find out if i have ABS on my front wheel bearing , on my 2000 dodge Dakota quad cab 2 wheel drive

User Avatar

The front spindle must be removed as the bearing is pressed in. Not a job for a beginner, but if you have some auto expertise, not too difficult...

User Avatar

Front is easy, just replace hub rear is pressed in

User Avatar

Top of rear axle.Could be one at each front wheel bearing.On driver side of transmission.Top of rear axle.Could be one at each front wheel bearing.On driver side of transmission.

User Avatar

how to replace front wheel bearing on 1996 Hyundai elentra

User Avatar

You can replace the front bearing on 2003 Citroen Relay using air tools.

User Avatar

start by taking off the driver side front bumper. its located right in front of the driver side wheel the rest should be easy.

User Avatar

Begin by removing the tire and wheel from your 1999 Dodge Adventure. Remove the end of the axle. Remove the wheel bearing retaining nut. Remove the wheel bearing seal and remove the wheel bearing. Reverse the process to install your new wheel bearing.

User Avatar

You can replace the front wheel bearing, on your Kawasaki Mule 3010, by removing the axle. With the axle Remove the wheel bearing will slide off.

User Avatar

you can replace it by taking it to the shop and they will do it for you.

User Avatar

To replace the front wheel bearing on a Ford Fiesta, you will need to remove the wheel. Then with a hammer you can pull the old bearing out.

User Avatar

just had a 93 golf cl front wheel bearing done at a garage all in ยฃ110.00 had a rear bearing done through my works workshop and the bearing cost ยฃ11.21 half an hour to do, gave the mechanic ยฃ20 i am not sure but i think the front bearing is the same and to dissasemble the front takes a bit longer but not 3 hours

User Avatar

Is the wheel bearing on the front or the rear ????.. There is a big difference ...

User Avatar

Dodge: front driver side.

User Avatar

to tell u the truth you are better off buying a new boot from a junk yard to put on then messing with the bearings

User Avatar

you need to press out the bearing inside the hub assembly.

User Avatar

Inside the fender, in front of the driver side front tower.

User Avatar

Inside the fender in front of the driver side front tire.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.