There is an access panel under the rear seat. Unscrew that and you will be at the fuel sending unit. Remove the sending unit and replace with new or used one, note that the fuel pump is attached to the float, so you will need to transfer it or replace it. BE CAREFULL! You will be working over open raw fuel, so make sure that there is fresh air and DO NOT smoke or create sparks or do anything that may ignite the fuel! After you are done just reassemble. Before you start make sure that it is the float and not your gauge.You can do tht by plugging the float into the wiring harnes at the tank before you remove the sending unit. Move the float up and down while plugged in and look at the gauge to see if it moves from empty to full as you move the float.
The fuel filter is probably in the fuel tank as are most fuel injected vehicles
This is fuel injected.. No float exists. This question could also pertain to the level in the fuel tank, which uses a float.
how do you replace the fuel pump on a 1997 buick lesabre
chevy
Its in the gas tank with the sending unit and fuel pump
Assuming that the fuel tank is empty--float should be at lowest position
sticking float on the fuel pump, or malfunction in the float
where are the fuel injectors in a 1997 oldsmobile aurora
The fuel pump on a Ford Aspire 1997 model is under the back seat. Take out the back seat and there is a plate in the floor with screws holding it down. Take these lose and the whole fuel pump housing and all will lift out of the fuel tank. !
Drop the fuel tank.
you must remove the fuel tank to replace the pump.
No you can replace the sender and float which is on the side of the pump usually around $40 most jobbers.