drain coolant. disconnect the inlet and outlet hoses of the heater core on the engine side of the firewall. (passenger side). remove heater core pipe clamp-bolt and clamp. from inside, remove the glove box(open it, squeeze sides in then pull ouit,remove hinge screws) for access to the upper core cover screw.below the glove boz, remove the dash insullating panel to access lower screw.remove evaporator temp sensor wiring clip from heater core cover if equipped with A/C. remove heater core cover,clamp bolt and clamp then slide out heater core. install is reverse.
Remove the water from your 2002 Chevrolet Camaro cooling system. Remove the water supply hoses from the heater core. Remove the heater core retaining bolts. Reverse the process to install the new heater core.
I changed out my heater core in a 1987 Z28 do you still need help with this? email me at MissionV19@KenTech.net Ken Willard
The heater core is behind your dash inside of the ventilation ducts.
VENT TO HEATER CORE IS NOT CLOSING................
it is behind the glove compartment. it will leak on the passanger side floor if it's bad.
The question you ask is too involved for a proper answer. You may want to go to a car parts store, and get a repair manual for your car. They cost about $16.00 Or, go to a Public Library.
it has a bracket with a 10 mm bolt holding both hoses together if it is the 1 i am thinking of it has rubber hose that comes out of the heater core but they both go into a aluminum hose down the p/s fender well then they go back to rubber
If you can smell anti-freeze when you are driving down the road it could be the heater core, if not check you anti-freeze level, if that is ok I would say it could be your thermostat. hope this helps.
How can do I replace a water pump on a 96 camaro z28
The 1993-97s did
I have a 81 Z28 Camaro, my heater hoses were behind passenger side fender by firewall. I would say start there, you might want to take off passenger side fender to get to it easier. The heater core comes from inside the car under the glove box.
Very few if any, part of the z28 package was the power windows.