0
How do you replace the license plate bulb on 1999 Cadillac eldorado?
Wiki User
∙ 13y ago
I have a 94 not sure if they are the same but behind the license plate was mine Good luck
Answer Improvement (Sept 5. 2010)
Remove 4 license plate screws and licence plate
Remove 4 hex head screws that hold the license plate/backup light assembly
Rotate the license plate/backup light assembly around 180 degrees so you can get to the light bulb holders
Carefully turn bulb holders 1/4 and remove bulb holder
Carefully remove old bulb and replace with new bulb (#194)
Reverse these step to reassemble
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Power windows wont work on a 1999 Cadillac eldorado?
Replace power window relay.Located under drivers side scuff plate.
How do you replace the license plate light bulb on a 2008 Cadillac STS?
if your under miles its under warrenty
How do you change license plate bulb on 2001 eldorado?
sledghammer
How do you change the license plate light on 1999 Cadillac eldorado?
Rear license plate lights replacement require that you remove the entire frame with reverse lights. Remove the 3 cover bolts on the inside of trunk, remove license plate, remove the for bolts holding frame to tyrunk lid, slide unit down and out and you will have to twist the bulb sockets and remove the bulbs and install in reverse.
Where is the throttle plate located on a 1995 Cadillac eldorado?
Should be at the bottom of the throttle body throat (inside)
How can you repair a 1998 cadillac deville license plate light?
my name is Jesse fondotsto replace a license plate light you first have to open the trunk of the car take out the carpet on the top of the trunk after that you will see two little black screws you take them out after you do that the silver peice will come off but before you can replace it you must take the two little screws out that are located right above the license plate. your welcome!
How do you replace the license plate bulb on a 2004 Honda cr-v?
how to replace the license plate bulb on a 2004 Honda cr-v
What size screw is needed to mount license plate on 1998 Cadillac STS?
The size of the screw needed to mount a license plate on a 1998 Cadillac STS is 1/4-inch?æby 1/2-inch. They make license plate kits that includes all needed hardware.
Where can one acquire Cadillac license plate frames?
You can purchase Cadillac license plate frames online at either Amazon or eBay. You might also want to check your local car retailer, the usually can order them at the manufacturer and sell them to you.
How do you replace license plate bulb on 2004 crv?
how do you replace a honda crv licence plate bulb on a 2004
How do you replace the license plate light on a 2005 Toyota Sienna?
how do u change the license plate light on a 2005 sienna
How do you replace license plate light on 2006 Pontiac G6?
how do you replace license pate light on 2006 pontia g6
