If your talking about a motor that powers a convertible top, then...
First, remove the spare tire out of the trunk, look in the far end of the trunk, where the spare tire is located, the motor will be on the right (passenger side). Disconnect the power, and ground wire, then the hydroulic lines.
Pull the motor up, it is only held by plastic plugs, once removed take your new motor, and make sure it is properly filled with automatic transmisssion fluid (If your a very specific person, use Chrysler type-3 automatic Transmission Fluid). Wire the ground, then plug it in, place it back on the platform where the old motor was located. The motor should now function properly function correctly. If it doesn't recheck all of the directions. If it still doesn't work, check the relay swicht and it's connections, you might have to replace the relay switch.
i need to learn how to take out my 1995 Chrysler lebaron convertible motor
It is behind the rear seat.
in the trunk.. upper right side...
Dexron auto trans fluid.
Yes, behind rear seat.Yes, behind rear seat.
Yes, along with switch, wiring, relay, motor,
remove back up tire in back right behind seat
It is behind the rear seat.It is behind the rear seat.
The wiper motor should be located on the driver side under the cowl grill below the wiper blade good luck
no.. very different.. by hard top you mean 4 door..?.. the 4 door window mech is a scissors action.... the convert is on a frame and cabled..
I was just searching the list and there is an answer to a similar question already in FAQ
behing the rear seat