answersLogoWhite
Auto Parts and Repairs
Chevy Lumina
Honda Accord
Ford Expedition XLT

How do you replace the lug bolt on the front wheels of your 1994 Chevy Lumina?

303132

Top Answer
User Avatar
Wiki User
2015-07-15 19:36:53
2015-07-15 19:36:53

Remove the rotor. Knock out the old stud with a hammer and pin punch. Take the broken stud with you to a parts store where they can match you up with a new one.

1

Related Questions

User Avatar

Visual instructions for replacing the front bumper on your Chevrolet Lumina can be found in most service manuals. The instructions can also be obtained from most auto-parts stores.

User Avatar

It is a involved procedure , if you have to ask then you shouldn't be doing that. the whole frame in the front has to come out.

User Avatar

Remove the positive cable from your 1992 Chevy Lumina battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.

User Avatar

What is the cost of a front end alinement.

User Avatar

The front wheel hub on a 1999 Chevy Lumina is connected to several suspension components. Loosen and remove all the components including the lower and upper ball joints. Pull off the hub assembly and install the replacement.

User Avatar

Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels Side of van along the frame Behind front wheels and in front of rear wheels

User Avatar

Standing in the front of the car it will be at the bottom right front corner of the engine.

User Avatar

Remove the wiring harness from the back of your 1995 Chevy Lumina front wiper motor. Remove the traveling arm linkage from the wiper motor. Remove the wiper motor retaining bolts. Reverse the process to install the new front wiper motor.

User Avatar

The 1993 Chevy Lumina 3.1 liter engine timing belt can be found on the front of the engine. You will need to remove the front engine cover in order to access the timing belt.

User Avatar

The front dash holder in the 1999 Lumina is screwed into the backside of the dash. Go through the glovebox to loosen the screws to replace.

User Avatar

There are four motor mounts located on a 1990 Chevy Lumina. Two on either side of the engine. One the rear and one in front of the engine.

User Avatar

5 1/4" in the front doors6x9" in the rear

User Avatar

This question needs to more specific. Disc or drum? Front or back?

User Avatar

Remove the tire and wheel from your Chevy Lumina. Remove the end of the axle. Remove the wheel bearing nut. Remove the wheel bearing seal and the wheel bearing. Reverse the process to install the new front wheel bearing.

User Avatar

The knock sensor, in your 1997 Chevrolet Lumina, can be found on the front of the engine. The knock sensor is near the top of the engine.

User Avatar

I recently had a 1990 Chevy lumina apv 3.1L engine put into my 1992 Pontiac transport, if that answers your question.

User Avatar

HOW DO YOU CHANGE FRONT WHEEL STUDS ON A 1995 CHEVY LUMINA AUTOMOBILE?

User Avatar

All wheels stay on the side that there on now. move front wheels to the rear and rear to the front. Do not change sides.

User Avatar

take the wheels off, unbolt the brake calipers and the pull them off and now you can just pull the rotors off.

User Avatar

The oil pump is found on the bottom on the 1995 Chevy Lumina's engine. It is mounted on the front of the crankshaft


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.