First things first. Compare the old to the new to make sure you have the correct replacement parts. And always SAFETY FIRST. To replace the master cylinder you will need to remove the air filter cover and snorkle tube. Remove the wiring harness from the mastercylinder reservoir then disconnect all four brake lines from it. Next remove the two retaining screws securing it to the brake booster.Transfer all needed items to your new master cylinder and put back on in reverse order. Bleed all four brake lines at the master cylinder and at the wheels and you are off and running again.
All Geo Storms are 4 cylinder
under the hood on the frame rail on drivers side, directly below master cylinder
how do i replace the exaust resinator on a 92 geo storm 1.6 liter sohc
To replace a thermostat on a 1992 Geo Storm first locate the its housing. Once found drain the coolant system and remove the housing from the engine. Replace the thermostat.
replace the exhaust.gmjim
You probobly need to replace the clutch.
Under your master cylinder against the firewall.
== == It depends what car and engine it was done in. If it was a D8 caterpiller that would have been a bargain. If it was in a Geo that probably is too much.
You ask a professional for help.
Under your brake master cylinder. Against the firewall.
Its located on the driver side fire wall just under the master cylinder. If you take the snorkel tube and air filter cover off it is much easier to see and change.
in the fill resivor attached to the master cylinder assembaly