Raise the front of the vehicle. Open oil fill cap on engine. Open drain plug on bottom of engine with wrench and drain oil out. Behind the engine on the passenger side is the oil filter. Place a filter removal tool on it and rotate counter-clockwise to loosen. Once loose you can spin off by hand. Watch your eyes. Clean off the surface and apply some new oil to the seal of the new filter and spin on. Hand tighten as hard as you can, do not use a tool to tighten unless you don't have the strength to give it a good twist. Replace the drain plug in the oil pan and refill the engine with oil. I changed my oil filter on my 1997 Saturn sl2 once and decided that I would not do it again. It is in an cramped place. It took me a long time to get it out, whereas an oil change company does it in about ten minutes.
Changing the oil on a '97 SL2 can be a bit of a pain, but really it's one of the easier cars to change. In comparison to, say, one of the late '90s Ford Tauruses, where you had to reach around the usually piping-hot exhaust pipe as it snaked down from the engine and along the undercarriage. The first answer is dead-on, but a small tip: if you lay a plastic grocery bag on top of the axle housing directly underneath the oil filter, you can avoid some really nasty dripping. The bag will act as a sort of conduit for the oil coming out of the filter to run down, dripping it straight into your oil catch-pan. Then when you're finished, just pull the bag off and all you have is a few drips to wipe off. Works like a charm for me.
The 1997 Saturn knock?æsensor is located on the back of the engine. The knock sensor can be removed by removing the wiring harness and the retaining bolts.
it is in the engine compartment, on the drivers side. not much room to work in. will need to take hose off from air filter to engine to get better access. it isn't fun, but good luck
Fuel filter is located on the fuel pump, which is located in the fuel tank.....good luck.
It is located about 1/2 way up the right underside of the vehicle. The same on a 1997 Chrysler Concorde How do i have to replace the filter Chrysler Concorde 1994? How do i have to replace the filter of Chrysler Concorde 1994?
Well in my 1997 accent it is located on the firewall in the engine if your engine is carburetor then it will be a plastic container
The oil filter is behind the engine on the passenger side. Just above the suspension. You'll need to get underneath to take it off.
its inside the fule tank drive safe
inline fuel under the car in the frame rail up front next the motor area.
the FPR(fuel pressure regulator) is part of the fuel filter assembly. Which will cost you about $60-$80
The oil filter is located on the passenger side of the engine I got at mine from the top of the car and found it easiest to replace it from there. It is down middle of the engine.
Under the brake master cylinder.
~$600