go to the parts store and get a rear view mirror mounting kit and follow the instructions to a T.
Restoring a classic car or refusing to give one up means finding the right parts. JC Whitney has millions of car parts, including a rear view mirror for a 1973 Oldsmobile Cutlass Supreme.
you have to turn the pistons at the same time you push the pistons in
Back seat has to come out and the rear package tray too and then you can get to the bolts that hold the speakers in.
Replace wheel cylinders and check rear proportioning valves.
What year?? This makes a big difference, especially with the early 90's on up.
what is the ratio of gears in a 1986 cutlass
The 1987 Oldsmobile Cutlass Supreme was rated 350 horsepower with the with the V8 engine. It was last year that the Cutlass was a rear wheel drive vehicle.
The rear license plate bulbs on a 1996 Olds Cutlass Supreme are replaced by removing the retaining screws, pulling the light assembly out, and disconnecting the wiring harness. The bulb can then be twisted to remove it and a new bulb put in place.
how to replace rear view mirror on a mercedes c-300 2009
Front = 3 & half, Rear = 4x10
Yes, My 72 Olds Cutlass convertible came with the light option package which included a map light in the rear view mirror.
find the tensioner pulley to release the belt. there should be two bolts on the top (one in front, one in rear) and one on the bottom rear ( this one is very tricky to get to).
The heater core on a 1984 Cutlass Supreme is located under the blower motor on the passenger side of the car, under the hood. First you need to remove the blower, and the hoses connecting the heater core. Replace the core, re-attach the hoses, and put the blower motor back on.
Equalizer valve not allowing fluid flow to rear?
twist it out and twist in the new one or you can just replace the mirror
Depends if it is the 3.1 or 3.4. I have a 3.4L and I let the dealer do it. The car had to be raised and the engine lowered since the alternator is located on the rear of the engine towards the bottom. See question regarding the 1995 Cutlass Supreme . Same applies unless you have the 3.4 version of engine.
The low side service port to recharge the AC on a 1997 Olds Cutlass Supreme is at the rear of the engine. It is close to the firewall.
the three coil packs are located above the rear rocker cover, near the firewall. -- In the way to replace the spark plugs.
Go to AutoZone.com website and look for repair manual on rear struts for this vehicle. Procedures are listed there for this.
Use strong glue to attach mirror
fuel filter is located above the rear axle
If this is a RWD Cutlass Supreme, ask the question again as:"How do you replace rear axle bearing on olds cutlass supreme?"Otherwise, remove the rear brake rotors and calipers if 4 wheel disc, drums and shoes if rear drum.Disconnect the rear wheel speed sensor electrical connector if 4-wheel ABS.Unbolt the four bolts holding the hub and bearing assembly to the spindle. I believe you will need a t45 or t50 socket. If you don't have a socket of the appropriate size, buy one. Remember that cheap sockets ruin bolts and ruined bolts ruin days.Use a hammer (about 1.5 to 2 pounds) to knock the assembly free. Hit it on the left side, right side, top, and bottom alternately.Use a bit of grease to ease reinstallation.