Disconnect - Battery cable Raise and safely secure vehicle Remove 2 mountig bolts Remove wiring harness Remove outer tie rod end remove cotter pin loosen slotted bolt Rap housing sharply w/hammer to release (should pop-up) Remove slotted nut twist and remove starter
diagram of starter in a 1993 ford probe
Probes were not made until 1989
a 99 ford probe doesnt exist
look at the lower rear end of the engine on the passenger side
The solenoid is part of the starter.
Check with local library for a repair manual, or automedia.com
If the starter is spinning but not catching, the problem lies in the starter drive (also called bendix). You will either have to replace the starter or repair it by replacing the bendix.
what type transmission fluid uses for a 1991 ford probe
It is in front of the radiator.
will a 91 Mitsubishi eclipse body parts fit a 91 ford probe
Replace it.
Make sure the starter is bad then remove the neg battery cable then the wires from the starter, take the bolts out that hold it on and work it out.