Starters and Ignition Systems
Nissan 200SX
Toyota Tundra
Ford F-250

How do you replace the starter on a 1995 Nissan 200 sx ser?

717273

Top Answer
User Avatar
Wiki User
2015-07-16 18:13:04
2015-07-16 18:13:04

You have to take the intke piping off and it should be right on the top of the trasmission. its pretty easy to get to i'v done a few.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

it can cost any were from 200 to 450 to replace the starter.

User Avatar

If you can get it to auto zone, they will check it free.

User Avatar

If you have a automatic it is located under your intake manifold.Answeri have a 1.6l 1995 Nissan 200 sx se manual trans its located right under the air entake box for fresh air

User Avatar

Usually located by where a hose or pipe goes into engine

User Avatar

Well, you figure about 200 for the new starter and allow up 200 for labor. It depends on the stuff that has to be moved to get to it. Also depends on the area of the country you live in for labor rates. They vary. It is a little less if you get a remanufactured starter, but that is your call. Good luck.

User Avatar

The cost to replace a Compressor varies. In general, the cost ranges from $200 to $500, depending on brand, store, and who is putting it in the car.

User Avatar

You might need to replace the fuel pump relay, as it tends to burn out in the 200 series. You might need to replace the fuel pump relay, as it tends to burn out in the 200 series.

User Avatar

make sure you have the right starter first. sr20de to sr20det starters are different, all u gotta do is unplug battery(do not forget) and unplug starter, undo bolts, swap them over, bolt up, and connect battery again

User Avatar

The ECU part for this car runs $150 to $300. To replace it, it can run the cost up another $100 to $200 if a person does the replacement at a shop.

User Avatar

The cost to replace a timing belt can vary from $60 to $200+. The cost depends on shop prices if it will be done in a shop, the brand and price of the belt.

User Avatar

Labor prices differ according to where you live. call a couple of local garages for estimates The starter is about $150-200. Double the amount if a shop is going to do the work.

User Avatar

Chiquititas - 1995 2-200 is rated/received certificates of: Argentina:Atp

User Avatar

Chiquititas - 1995 3-200 is rated/received certificates of: Argentina:Atp

User Avatar

Chiquititas - 1995 4-200 is rated/received certificates of: Argentina:Atp

User Avatar

Chiquititas - 1995 5-200 is rated/received certificates of: Argentina:Atp

User Avatar

Chiquititas - 1995 6-200 is rated/received certificates of: Argentina:Atp

User Avatar

to replace it yourself it would cost about $200 for the part NEW and about $170 for a refurb. the job will take about an hour and anywhere from $50 - $150 labor if you took it somewhere.

User Avatar

Bearing & seals will run you about $150-$200 for parts and about 2 hours labour

User Avatar

200 Nissan exterra v6 have spark and injector pulse no power to fuel pump

User Avatar

Take it to a mechanic.... use a 12 mm extended ratchet to loosen the accessory belt tensioner (remove belt) Unbolt the alternator from the engine chassis and unplug the positive and negative terminals. New Alternator Costs about $200, New Starter Costs the Same.

User Avatar

Expect a shop to charge around $200. It's a real easy DIY task, if you feel so inclined.

User Avatar

The owners manual for my 1995 200 SX SE-R indicates that timing "chain" does not need replacement. Unlike timing "belts" found on many cars which likely require replacement at 60,000 or 100,000 miles.

User Avatar

The cost to fix a broken starter depends on the type of starter and where a person goes to fix it. It can range from $50 to $200 to fix a broken starter.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.