Ford Ranger
Ford Ranger XL
Ford Ranger XLT

How do you replace the starter on a 1996 Ford Ranger?


Top Answer
User Avatar
Wiki User
2006-07-18 20:57:01
2006-07-18 20:57:01

everyone should have a manual for their vehicle, and a professional shop manual should be available at your local library in the reference section, make copies of the appropriate pages, and good luck:)


Related Questions

1996 ranger does not have speedo cable it is electronic

on the passenger side underneath where the motor and transmission meet

How do I remove air from the cooling system of a 95 ford ranger 4 cyl

The 2004 Ford Ranger starter is located on the right hand side of the engine. The starter will be at the back of the engine.

How do you replace a 2003 Ford Ranger radio

Make sure the starter is bad then remove the neg battery cable then the wires from the starter, take the bolts out that hold it on and work it out.

Disconnect the - battery terminal Raise and support vehicle if neeeded Disconnect wiring from starter Remove mounting bolts Remove starter

Disconnect the - battery cableRaise and support vehicleDisconnect wiring harness at top of starterRemove starter mounting boltsRemove starter

how to replace water pump on 2001 ford ranger

To replace the brake light bulb on a 1996 Ford Ranger is very simple. There are four bolts that hold the housing that will need to be removed. After the bolts are removed, the wires connector needs taken off and then the bulb can be twisted out.

how to replace u-joints on 1995 ford ranger 2wd

where is the fusible link on a 1996 ford ranger xlt

how do i replace a throttle cable on a 1988 ford ranger pickup

( # 17 ) is a 15 amp fuse for the cigarette lighter in a 1996 Ford Ranger

where is the shift solenoid on a 1996 ford ranger 4x4 with a 4.0 v6

how do i replace front wheel bearinbs on 2000 ford ranger 4wd

A 1996 Ford Ranger could be equipped with a passenger side airbag ( SRS ) * so maybe yes and maybe no * All the 1996 Ford Ranger models have a drivers side airbag

# Disconnect negative battery cable # Raise truck and support it # Disconnect the large cable from the terminal on the starter # Remove 4 bolts or nuts securing the starter and remove the starter from engine

what does a fuel pump look like in a 1989 ford ranger 4 cyl.

YES - lists a DPFE sensor for all available engines on a 1996 Ford Ranger

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.