Saturn S-Series

How do you replace the thermostat located on a 1996 Saturn SL2?


Top Answer
User Avatar
Wiki User
2011-09-12 21:04:48
2011-09-12 21:04:48

as youre facing the front of the car on the left you will see the water hose from the radiator to the engine block take it off on the block side you will see 2 bolts I think they will be either a 15mm or 12mm remove this and you will see the thermostat I have a 97 Saturn and this is where mine was located I do believe they will be the same since the engine has not changed much good luck hope this wasnt too late be careful with the anti freeze when you take off the hose pets have a strange likeness to it


Related Questions

The thermostat is usually located on the lower hose, where it attaches to the radiator

follow the top radiator hose to the engine, remove it then remove the thermostat housing, remove the thermostat and replace it

Where is the thermostat located on a 1996 Toyota Tercel?

Need to know where is the thermostat located on a 1996 mercury tracer.

Locate thermostat on 1996 Acura RL

follow the 2 water hoses off your radiator. one will lead to a housing containing the thermostat. usually has 2-3 bolts.

Its on the drivers side, under the hood, in the engine compartment. Eric

Loosen the alternator bracket, move it out of the way. The thermostat is at the end of the upper radiator hose where it curves into the engine

The thermostat is located inside of the thermostat housing on the front of the engine. You can follow the top radiator hose to the thermostat housing.

1996 3.1 litre ThermostatThe thermostat on a 3.1 litre is located under the throttle body where it connects to the intake manifold. I found it was easier to remove the throttle body when replacing the thermostat. You first have to remove the throttle cable bracket that is mounted on the throttle body. After that you will be able to see the thermostat housing. The bottom hole on the thermostat housing is slotted so you don't have to completely have to remove it. Good luck!

where is the thermostat located on 1996 mitsubishi galant 4 cyl

You can uninstall thermostat and install new thermost under air filter and look coolant hose by sensor gang. I did my own car.

Unless the housing is damaged, there is no reason to replace it. Just replace the gasket.

The water pump on a 1996 Saturn sl2 is located in the engine compartment. It sits below the AC compressor.

Depends on what size engine you have, and what year of Grand Am you have. Mine is a 1996 with a 2.4L engine. So my thermostat is located in the bottom radiator hose, where it goes into the water pump.

replace anti-freeze, replace thermostat

simply find the top radiator hose and follow it down to the engine. That is where the thermostat housing is with the thermostat being located there.

I would start with checking your thermostat and thermostat housing. See if its regulating. If it is not replace the thermostat.

Replacing the thermostat on a 1996 Grand Marquis is not very hard. First, follow the upper radiator hose to find the thermostat. Then disconnect the hose and drain it. After the hose is drained, remove the bolts holing the thermostat housing in place. Take the old thermostat out and replace with a new one.

the thermostat is located towards the bottom of the engine you can recognize it by a cable that connects to the front of the middle of the engine and in order to replace it you pretty much have to take the front of the car off

it is located onder the car.

The thermostat on a 1996 Jeep Cherokee is under the housing where the upper radiator hose attaches to the engine.

when you lift up the car the thermostat is located on the right front bottom of the block you'll see a radiator hose by the compressor ,the thermostat goes inside a small housing and it is a little difficult to put back in because the gasket has to place properly

Water pump location on a 1996 DevillWater pump is located under the thermostat on the drivers side of the engine

Take off the thermostat housing which is located right where the top radiator hose clamps to the motor. thermostat will come right out. be sure to install the new one in the same way you take the old one out.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.