first it's a pain. you have a GM steering column so parts are not a problem but you will need some special tools to make this happen. one is a steering wheel puller the other is a lock plate remover. pop the steering wheel center off and you will see a big nut, remove it first then install the puller and pop off the steering wheel. remove plastic dust cover and install the lock plate removal tool. tighten it up until you see a gap around the "C" clip at the base of the steering shaft. using two small screw drivers push down (yes down) on one end of the clip. insert the other small screw driver in the groove that you just pushed the c clip out of. now, with that in place, take the first screw driver and slip the clip over the second driver and walk it around until its free. (this can be very trying so be prepared). once the c clip is free remove the tool and the lock plate. you now for three screws that hold the switch in place. remove them and the emergency 4 way button and turn signal lever. now for the fun. under the dash and on top of the steering column is a long flat connector. remove it from it's mount, separate the connector and carefully pull the switch and connector out. fish the other one in and reverse the removal instructions. good luck, as this can be a 12 pack job.
The turn signal switch is quite easy to remove and replace. The turn signal switch simply plugs in and plugs out.
How do I install a turn signal switch for a Chevy 2000 Impala? WHere is the old part that I need to replace?
replace turn signal kit on 1964 impala
The turn signal cam is broken on the switch side. You need to replace the turn signal switch assembly.
turn signal switch.......... Good Luck..........
The 2003 Chevrolet Silverado turn signal switch is located below the dashboard, on the drivers side of the passenger compartment. The turn signal switch simply plugs in and out.
Pull steering wheel, remove steering plate to access turn signal switch. There are two swings as you look down at switch that should be broken. Your Cam spring is broken. best to replace turn signal switch
Replace the turn signal flasher relay.
turn signal switch is the hazard button! Pull out hazard button and replace it! good luck!
To replace the turn signal switch of a 1996 Dodge Caravan, open the engine's hood to access the front turn signal bulbs. Then take the headlight assembly a little off the front to give room to get the bulbs. Remove the old turn signal switch and slip the new one in place.
To fix a stuck turn signal, you may need to replace the whole switch. A switch can be purchased at any auto parts store.
pull the steering wheel off and then you will see how the turn signal unit comes out.