Want this question answered?
On the driver's side valve cover towards the back of the engine, on top.
Remove the plastic cover if your car still has it installed and remove the bolts holding the covers on and remove, the drivers side is a pain, you may have to remove other parts so they can be removed.
Hope you have small hands and the right tools.
You have to remove all the hoses etc. from the top of the engine and on the drivers' side you have to remove the brake master cylinder so the cover can clear, it takes time and it's a pain to do, good luck.
Valve cover gaskets are leaking. The valve cover gasket has seals as well around the sparkplug openings. These seals leak and leak oil into the sparkplug wells. drl
Its inside the passenger side front fender. Remove the plastic cover. Replace as you would any other Lincoln filter.
You have to replace it.
1. Mark your plug wires 1-4 2. Remove your plug wires 3. Take off the 2 to 3 hoses connected to the Valve Cover. 4. Remove the 4 bolts from the coil packs and remove coil packs 5. Remove 6 bolts from Valve cover. 6. Clean up valve cover and make sure no gasket is left over. 7. Put new gasket on and repeat this in reverse for installation. Note: You will have to call Autozone or a local dealership to find out the torque specifications on your valve cover bolts. I usually replace them, but it is not necessary.
The pcv valve is in the dirvers valve cover top center and the 02's are in the exhaust close to the manifolds they are a pain to get to and very hard to see with out a lift. there are 2 sensors 1 on the driver side an passenger side. good luck
hi man i am awsome
Front or rear?
Go to http://www.lincolnvscadillac.com/tech/lincoln-mark-viii/Coil-Spring-Conversion/index.htm