Water Pumps
Oldsmobile Ciera
Oldsmobile Cutlass

How do you replace the water pump on a 1991 Oldsmobile Cutlass Ciera Cruiser 3300 3.3L V6?

636465

Top Answer
User Avatar
Wiki User
2015-07-16 18:31:19
2015-07-16 18:31:19

I have the same car. I also just had to replace the water pump. Cost me about 200.

1. Drain cooling system. 2. Loosen and disconnect hoses. 3. Remove the pulley bolts and the pulley (wedge a screwdriver between the two bolts to prevent the pulley from turning). Loosen all bolts before removing any of them. 4. Remove retaining bolts and remove water pump

When installing, put a new gasket and sealant on the bolts.

Good luck.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

Where is the signal flasher located on a 1987 Oldsmobile Cutlass Ciera?

User Avatar

how do you replace the headlight switch on a 1993 cutlas ceria*

User Avatar

How do you change the heater core on a 1989 Oldsmobile Cutlass Ciera? or where can I get the Info on replaceing it

User Avatar

what is the oxygen sensor location on a 1993 oldsmobile cutlass ciera 3.3l v6

User Avatar

where is the knock sensor located on 93 cutlass ciera

User Avatar

What would make a 1899 oldsmobile cutlass ciera start and then die right away?

User Avatar

i have a question. I was told I owned a OLDSMOBILE CUTLASS CIERA but I don't remember ever have a car that a was an OLDSMOBILE CUTLASS CIERA. Can you help me?

User Avatar

The Kelley Blue book on a 1992 Oldsmobile Cutlass Ciera ranges from $1825 - $2175.

User Avatar

The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.

User Avatar

Where is the choke sensor on a 1991 Oldsmobile ciera 3.3L

User Avatar

Sometimes the flasher relay on a 1992 Oldsmobile Cutlass Ciera is located in the fuse box. Other times it may be located under the dash near the steering column.

User Avatar

1995 Oldsmobile Cutlass Ciera turn signal flasher is behind the fuse panel. The 4-way flasher is to the right side of the glove box below the horn relay.

User Avatar

The door lock/unlock relay is located behind the I/P on a 1995 Oldsmobile Cutlass Ciera. The relay is at the RH shroud just beside the center access hole

User Avatar

The firing order for a 93 Oldsmobile - Cutlass Ciera S is................ 123. 456 going upwards...that what it is on mine. thanks Dee

User Avatar

On the 3.3L V6 it is under the radiator cap.

User Avatar

The Cutlass is an automobile made by the Oldsmobile division of general motors. The Cutlass was introduced in introduced in 1961. The curb weight for the Cutlass automobile is 4,500.

User Avatar

The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.

User Avatar

Code 42 on an Oldsmobile Cutlass Ciera means you have a faulty ignition control module. You should inspect all electrical connectors to ensure they are tight.

User Avatar

It should Be located on the top of the transmission.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.