Water Pumps
Windshields and Wipers
Oldsmobile Bravada

How do you replace the water pump on a 1992 Oldsmobile Bravada?

656667

Top Answer
User Avatar
Wiki User
Answered
2015-07-16 18:13:54
2015-07-16 18:13:54

first you will need to remove the top fan shroud next remove the serpentine belt next remove the fan clutch assemble then remove outer pulley you should have four bolts holding it on after that you will be able to see the water pump you should have four 15mm bolts holding it on remove them and to gaskets then you install the new pump it's easy. The whole job should take less than 1hr

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


GM vehicles are not equipped with such a switch.

Is there a picture of a Starter Solenoid for a Oldsmobile 1992

4.3 L V6 firing order is 1-6-5-4-3-2 Distributor rotates clockwise.

how do you install a water pump on a 1992 toyota camry

How to set clock on a 1992 oldsmobile achieva

If that is throttle body fuel injection, there is no fuel pump test port. You have to fabricate with some fittings and tap into the fuel line at the fuel filter.

Oldsmobile Achieva was created in 1992.

you maybe blew the motor have u tried ur spark plugs distributor cap and all that

is it hard to change the water pump on a 1992 Oldsmobile achieva. Yes, it is very hard to replace a water pump on an Achieva. When the pump died on my 1996 Achieva, the engine needed to be unbolted and removed to get to it. As I recall, it cost about $500. I have a 95 Olds Achieva 3.1 and the water pump was very easy to change. Mine is on the front passenger side of the engine. Very easy to get to, just be careful not to break any bolts off. lol

A 1992 Oldsmobile may not shift out of park because the transmission is stuck. Check to transmission fluid to ensure it is at the proper level.

How do you replace the clock on accord 1992

the water pump is on the bottom of the engine underneath the alternator

It takes a special tool. I got mine from Autozone and had a guide from them on how to replace it. You'll have to remove the belt and harmonic balancer and access it through the passanger side front tire.

How do you route a serpentine belt on a 1992 Cierra Oldsmobile

How do you replace evaporator on a 1992 ford explorer?"

The 1992 Oldsmobile Cutlass supreme has two oxygen sensors. Both oxygen sensors are located on the outside of the air cleaner housing.

Remove the belt from your 1992 Chevy Lumina water pump. Remove the water pump return hose. Remove the water pump retaining bolts. Reverse the process to install your water pump.

It is located in the fuel tank.

This is same procedure as detailed in the "Related Question" below.

When I first realized I had to change the water pump in my Grand Am it looked pretty daunting and I wasn


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.