Water Pumps
Windshields and Wipers
Plymouth Acclaim

How do you replace the water pump on a 1992 Plymouth Acclaim?

767778

Top Answer
User Avatar
Wiki User
2015-07-15 19:44:47
2015-07-15 19:44:47

This is a big job. I suggest getting a manual on your car from AUTOBOOKSONLINE.COM.

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

From the screw tabs across is just under 6.5". I bought 5.25" and the fit (1992 plymouth acclaim) except the screw tabs are too short

User Avatar

My 1991 Plymouth Acclaim manual says mine is R12, but I can't say for the '92 It was built with R12, should be retrofitted to R134a.

User Avatar

The oil filter is on the lower front of the engine.

User Avatar

No crank sensor. Only has the distributor pick up plate.

User Avatar

may be the ignition coil! happened to me, otherwise check battery of course. or wires.

User Avatar

It has four cv joints, two in each front axle shaft.

User Avatar

Could be clogged injectors. Run a pint of Sea Foam in the gasoline. No guaranty's but it has worked for me.

User Avatar

Look at my answer for the location of the fuel pump fuse for the '93 Acclaim. Might help you. I found the relay.

User Avatar

Your problem is prob the starter, if you hear grinding it def is, Tho if starter is good could be ignition relay

User Avatar

how do you install a water pump on a 1992 toyota camry

User Avatar

There are two (2) horns behind front bumper. I believe that right side is high tone and left side is low tone.

User Avatar

I have a 1992 acclaim, the speed sensor is located on the right hand (passenger) axle. Look on the back side of the axle,about 6 " down from the transmission, you see a lump on the housing, with 2 or3 wires leaving the top.

User Avatar

Remove upper upper mounting bolt and nut. Raise and support front of vehicle. Remove lower mounting bolt and remove starter.

User Avatar

Remove the wiring harness from your 1992 Plymouth Grand Voyager alternator. Remove the alternator belt. Remove the alternator retaining bolts. Reverse the process to install your new alternator.

User Avatar

If you're that determined to not buy a new one, you send it off to get rebuilt. Results may be varied, and the cost won't save you much - if anything - over just replacing it.

User Avatar

It is much easier to reach them if you remove the air filter box itself. They are basically opposite the front ones.

User Avatar

First of all is it the 2.5L 4-cyl or the 3.0L 6-cyl? A Haynes manual for any Dodge or Plymouth using your engine actually has plenty of info. I used a manual for a 1989 Dodge Caravan to change the belt on a 1995 Plymouth Acclaim 3.0L. The engines look identical. If you have the 3.0L: Quick connect fuel lines are in the way. Will have to support the engine to remove the motor mounting. Remove the large motor mounting engine bracket. Remove the serpentine belt. Remove upper timing belt covers. Remove various pulleys AFTER setting TDC. Unbolt and move power steering pump and A/C compressor. Absolutely definitely should replace WATER PUMP too because it is driven by the timing belt. After belt off, check timing belt tensioner by spinning it. Pros will replace it with timing belt.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.