The water pump is behind the cover that the serpentine belt runs under(?) to make with the spinning of the fan. Remove the plastic fan cover, remove the fan blade, the cover slips right off and the water pump is right there. The studs that hold the fan blade in place are attached to the water pump.
I seem to remember having to remove the Power Steering pump and loosening the alternator to get the belt off.
Also most likely a new water pump will not come with the studs to mount the fan. If it is anything like mine, the studs will not come off the old one easily, if at all. Your best bet will be to pick up a new set of studs at the same time, if for no other reason then to save a trip to the store when you have half your engine lying around outside the vehicle.
Hey Andrew==It does take a certain machanical ability and tools but is not hard. When starting out like this, it is best to get s shop manual on your car to help you identify parts etc. GoodluckJoe
Replace water pump and gasket
how to replace the slave cylinder on a 1993 jeep wrangler
How do you replace the clutch slave cylinder on a 1989 jeep wrangler
The correct factory tire size for a 1994 Jeep Wrangler is 215/75R15.
Certainly, they are both YJ"s.
Yes, it will fit just fine.
you jet some glass that fits a 1995 jeep wrangler
No, the 94 will be 5X4.5 and the 2010 will be 5X5
my jeep wrangler is starting to have a hard time to start in the mornings? my jeep wrangler is starting to have a hard time to start in the mornings?
how do you replace a blade wiper motor on a jeep wrangler 2006
More than likely the Flasher Relay is defective. Replace it.
Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5
Al YJ's are compatible, 89-95
It does no have one.
A 1994 Jeep Wrangler needs approximately 6 quarts of oil for an oil change.
No.Jeep Wrangler wheel lug patterns years 1987-2006 are 5X4.5Jeep Wrangler wheel lug patterns years 2007-2014 are 5X5
it will fit no problem