myself i took the belts off first and used a 10 m socket and rench it is in a very tight location after you take out all the bolts use a long flathead screwdriver to break the seal when replacing with the new pump make sure it is cleaned wiped down it took me about 3 hours to do. undeneath the front passenger side be sure to take the plastic panel off to give you the extra room needed.
I am adding that you should remove the top engine bracket on the 1.6L(3, 14mm bolts), for extra room. Watch the UTube Video on how to remove, or adjust the belts, and get them out of the way. A ratcheting wrench would be the best, for those 10mm bolts. mark where the long one goes. Make sure you don't remove the wrong bolts by looking at the new water pump, to see where they are located; once they are loose enough, they should come out with the fingers. Don't remove the pump's pulley until you have it out of the car.
How do you reset the security system 1995 Nissan Sentra?
The thermostat on a 1995 Nissan Sentra 1.6 is located behind the water inlet. The water inlet is positioned at the end of the lower radiator hose.
The thermostat on a 1995 Nissan Sentra 1.6 is located behind the water inlet. The water inlet is positioned at the end of the lower radiator hose.
Use strong glue to attach mirror
how to replace water pump on Nissan quest 3.0 1995
The control arm has to be replaced . for a 1995 sentra it costs 172$ at the dealer and on the web it available for 100$ each .
The speed sensor is in the engine compartment on a 1995 Nissan Sentra GXE automatic transmission. It is on the back of the transmission.
bottom of the radiator
1342 couter- clockwise
no its part of the starter i belive
It should have a spring loaded automatic tensioner, if the spring is broke replace the tensioner arm assembly
It is on driver side top of firewall right behind strut