First, disconnect the negative battery cable. Then drain the coolant into a pan by loosening the drain plug on the bottom of the radiator. In order to access the water pump, first remove the drive belt, alternator, belt cover, engine hose, heater hose, and radiator hose. Remove the water pump, then clean the engine around the mounts with degreaser. Replace gaskets and spread silicone on the water pump to secure them. Install the new water pump and replace the bolts and all other hardware that had been removed. Refill the radiator with a 50/50 mix of coolant and reattach the battery cable.
where is the water pump located on 1997 honda accord
if i replace the water pump i have to do the timing bell
remove and replace water pump in 1997 Oldsmobile aurora
How to install thermostat in a 1994 volkswagen golf?
Water pump
The average cost to replace your 1997 Chevrolet Blazer water pump is $230. The water pump will cost approximately $80 and require two hours of labor.
You must remove the timing belt to get to water pump.
water pump on this 3.0 is driven with the timing belt. it is internal water pump you will have to set your timing before you start replace your timing belt if it is worn out.
You will need to drain the water from your 1997 Mercury Villager cooling system. Remove the water pump belt. Remove the water pump hose. Remove the water pump retaining bolts. Reverse the process to install the new water pump.
yopu have to have a special tool to do it .
45minutes
I have a 1997 Toyota Camry. It is leaking anti-frezze. I need to replace the water pump. Do I have to remove and replace timing belts too?