First get yourself a wiper removal tool. The wiper arms are very hard to get off. Then remove the 4 screws holding the interior air filter cover on the passenger side. Pull that cover out. Then stick a large screwdriver under the flat part of that large black plastic cover and loosen it from the clip under it all along the front. It should then be able to be moved up and out through the top. Always get the wiper motor and transmission as a single unit at a junkyard as once the motor is separated from the transmission it is very hard to get the proper positioning back. There are only 3 bolts holding the wiper/transmission unit to the car. Put some oil down through the top side of each wheelbox before you put it back together. The wheelboxes are the the parts that the wiper arms go onto. Then put all the parts back on in reverse order.
how do you replace a wiper motor in a 2000 jetta?
Replace thermostat on 2000 vw jetta
how to change the windshield wiper motor in a 2000 jeep wrangler
As long as they are both mk4 jettas the wiper linkage should fit. If you need to purchase the wiper linkage. Check out this website. http://twinlys.weebly.com
There is no switch. If the wipers park in the middle or at the top of the winshield you need to replace the motor. the fault is in the logic
If intermittent wiper won't work either, it is most likely a bad wiper motor. Had a dealer replace the wiper switch, but that did not fix either problem. After dealer replaced wiper motor, problems were resolved.
www.sunvisordepot.com.they are great!
in the front side of the wiper motor
Bad switch or bad motor is most likely cause. Motors should have been recalled by Chevy. If you replace motor, replace with new one- do noy replace with a rebuilt motor.
REPLACE THE MOTOR But first make sure the nut attaching the wiper cam to the motor is not loose or has slipped. When the wipers were turned off on my 2000 LS1 they stopped at 12:00. When I turned them on they went first to 9:00 then to 2:00. I was going to replace the motor but noticed the motor always runs one way and the wipers reverse by a cam. The cam was out of sync with the motor because the nut on the motor shaft had allowed everything to slip.
There aren't any switches to check/replace i.e. wiper switch, wiper relay therefore it must be a bad motor.
2000 buick regal wiper pulse board /timing wipers