Want this question answered?
How do you replace the CV joints on a 1993 Nissan Sentra XE?"
where is location of thermostat in ford aerostar van, 1993
lmc truck (www.lmctruck.com). there is a diagram for upper and lower ball joints for the front end.
It is best to replace the whole axle, Its easy to do not to mention pretty inexpensive....
The 1993 Aerostar does not use R-134a. It uses R-12.
Yes they are compatible
yes you can all you need to do is change the tail shaft cover between the two transmissions
On a 1993 Ford Aerostar 3.0 ( and 4.0 ) 3 - 6 2 - 5 1 - 4 front of Ford Aerostar
A 1993 Ford Aerostar would have come from the factory with ( 5W-30 )
On a 1993 Ford Aerostar , 3.0L V6 engine : The distributor is located on the TOP of the engine , near the REAR
take tire off then the break caliper then undo the upper ball joint then unhook the strut fron the a arm. undo the axle nut and pop it out of the trans. then your done not to hard.
A 1993 Ford Aerostar ( 3.0L and 4.0L V6 engines ) came from the factory with ( 5W-30 )