How do you reprogram the keyless transmitter for a 2002 Pontiac Firebird?

Answer 1

1. Turn the ignition switch to the ON then OFF position.

2. Remove the RADIO fuse.

3. Cycle the ignition switch from the OFF position to the RUN position (as far as you can go

without cranking the engine) 3 times within 5 second ending in the RUN position. The

vehicle will verify entry into the programming mode by locking then unlocking the

door locks.

4. Press and hold both the LOCK and UNLOCK buttons on the first transmitter for

approximately 15 seconds. The vehicle will verify programming by locking then

unlocking the door locks. Your new remote has been accepted and all existing

remote codes have been erased.

5. Repeat the previous step for each additional transmitter (including any existing

transmitters). You may program up to 4 transmitters.This must be done before the

RADIO fuse is reinstalled.

6. Place the ignition switch in the OFF position. IMPORTANT: The remote keyless entry

system will not be operational if the radio fuse is open.

7. Replace the RADIO fuse. If at any time it is necessary to restart the procedure, turn the

ignition OFF and proceed again with step number 1.