The guy at Pontiac said it requires a series of steps. He wasn't even sure. The Pontiac dealership will program it though for $60 so this question is really worth answering. Sorry I couldn't help.
how do you program a keyless remote for a 94 Dodge Intrepid. I battery died and now the horn keeps going off
Look in your owners manual if you still have it.
i am not sure what you mean. do you mean how do you program the keyless remote. if so try this link http://www.blazerowners.com/keyless.htm
The RKE harness (remote keyless entry) is located under the center console. My guess is your looking to program a remote. The wires you jumper to do so are A and G. These are purple and black. -jeff
http://www.nissanpathfinders.com/remotes.htm Nissan Pathfinder lost remote or new remote. How to program or reprogram the Pathfinders Remote control.seat is a box which is the sensor for the remote...........Go to this page and it will tell you how to do it.P.S. you can buy remotes online at e-bay
How do you reset the security code on a 1994 ponitac firebird formula......
Yes, it will.
No it will not.
There is no coil pack on that year.
On my 94 Jeep, you can disarm the security by unlocking the hatch with the key. So, you don' HAVE to buy a new remote, but it is more convenient than going to the back of the car and turning the key every time the security light comes on.
Does it crank? do you have spark? fuel?
if you mean the 3.4 v6 123456
there is a ignition fuse under the hood, no starter fuse
driver side kick panel
yes with extensive work and modification
THE KEYLESS ENTRY MODULE.
all firebirds 94 and up take 134a freon
a 94 gets 195hp so
Sometimes it is eassier to get to them from the bottom.
For a 94-97 (may work for 98) single button remote: - Flip Valet switch to ON position - With key in ignition, turn key to ON, then OFF - Flip the valet switch to OFF, then ON/OFF, ON/OFF (that's twice), and you should hear a confirmation siren chirp. - Turn the ignition switch On/OFF, ON/OFF (twice), and you should get another confirmation chirp. - You are now in programming mode. Push button on the remote, and you should hear a chirp to confirm programming completed successfully. - After 5 seconds, the programming mode will close automatically.
THIS IS FOR A 93 BUT I WOULD THINK IT WOULD think it would also work on that 94.. programming 93 Jeep keyless fob This works for the 1993 Grand Cherokee: Sit inside the vehicle with all the doors closed. Place ignition in the OFF position. Open the driver's door. Leave Open. Move the mechanical door lever to the LOCK position. Turn the ignition to the RUN position. Aim the transmitter at the Keyless Entry receiver and press Lock button. Hold for five seconds until the door locks cycle. Turn ignition OFF within 20 seconds. good luck........
from what i know yes. the method is different with a v6 and a v8, but otherwise doesn't differ until the 98 model.