take it to a Toyota dealership, have them run the code through the scan tool and reset the light as necessaryAnswerYou could, if you want to waste your money. All you have to do is disconnect the negative cable from your battery, wait a minute and reconnect it. This resets your computer. Also, you can buy a cheap code reader for around $50 instead of paying around $80 to get it done at the dealership. They are easy to use and plug in usually under your steering wheel or under the seat. They are useful for finding whats wrong but wont tell you great details like the expensive ones do.
After the repair, you reset it with an OBD2 scan tool.
Have vehicle scanned to determine the problem
The Check Engine Light has nothing to do with oil changes. It is on because there is a problem with the emissions system.
By repairing the problem that caused the Check Engine light to come on in the first place. You can then reset the CE light with a scan tool. Reset the light without repairing the problem and it wll just come back on.
take postive side of battery off then put back on
I don't know about the 2000 year model directly but the 1996 is similar I am sure. To reset the "check engine" light, find the EFI fuse (probably under the hood in the fusebox on the driver's side) and with the engine off, remove it for one minute minimum. Replace the fuse and the "check engine" light should be reset.
You reset the check engine light with a scan tool after repairing the failure.
The check engine light has to be reset with a OBD scan tool
take off the positive cable on the bettery and turn on the key switch for 5 minuts then put battery cable back on and the check engine light should be off
on most vehicles if you disconnect the battery cables it will reset the check engine light
hoe do you reset the check engine light in a 1995 land rover
how do i reset the check engine light on a 1999 acura 3.2tl
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light comes on in a car when there is a problem with the engine. It will go off or be reset when the problem is fixed.
There is no reset button for the check engine light. It must be reset with an OBD scan tool.
You need a scan tool to properly reset the check engine light.
How do you reset check engine light for the 2009 Chevy trail blazer?
The check engine light can be reset two ways. 1) If the problem resolves itself, the check engine light will reset itself after a certain amount of cold starts of the car on the on board computer system. 2) You need an OBD reader that has the reset check engine light capability.
To reset the check engine light on a 1998 Honda Civic located the blue 15 amp fuse in the engine bay fuse box. The fuse is labeled ECU, and will reset the check engine light when removed.
The check engine light has nothing to do with an oil change. The check engine light is reset with a scan tool after repairing the failure that caused it.
Reset the Check Engine Light by disconnecting the battery for about 10 minutes.
It is important to make sure the check engine light is not on when having a car inspected. A person can reset the check engine light by clearing the codes that are causing the light to go on.
how do you reset check engine light in 2008 buick lucerne
How do you reset engine light on jeep liberty diesel
check engine light reset on a 1999 acura cl 3.0.. Just replaced the egr valve. Thx