Use a generic OBDII code reader, scan tool, or Tech2 to clear the codes. Alternatively, you could disconnect the battery (under the rear seat) for a few seconds.
Not directly. There are fuses for the engine computer and it is what turns the light on.Not directly. There are fuses for the engine computer and it is what turns the light on.
The engine computer through the brake light switch.The engine computer through the brake light switch.
It is very easy to change the license plate light on an Oldsmobile Aurora. All you need to do is remove the license plate and look above where the plate was. There are bolts that are holding the light in. Unscrew the bolts and then replace the light.
What engine light? If you are referring to the check Engine Light, then the computer has detected a problem that effects the emissions controls.
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.
2 ways, autozone can reset the light,no charge. But they can also tell you what the code # is and what you might need to repair it. Or you can disconnect the battery for approx. 5 Minutes, that should reset the cars computer.
No, the check engine light comes on when the computer detects a malfunction and sets a code.No, the check engine light comes on when the computer detects a malfunction and sets a code.
The check engine light comes on when the computer detects a malfunction and sets a code.The check engine light comes on when the computer detects a malfunction and sets a code.
It is illegal to disable the check engine light.
Disconnect and reconnect the ground cable from the battery or remove and replace the fuse that controls your computer.
Because you removed the computer.
remove it and it wont start if that light burns out oris removed the eng wont start it shuts down the computer on most new modles